Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Labels

Forum Posts

Hello,I have two 2811 Routers. Can I connect them using DSL lines from ISP on two ends? What would I need to implement it. It is just for connecting two offices.Thanks,Pranav.

How many pps or Mbps cleartext would you expect from a 1721 between the built-in 10/100 port and a 10/100 port on the four-port switch module, using IOS firewall? I've seen numbers for encryption (the unit has VPN bundle), but have no idea how the ...

Hello, We have a cisco 1721 having one "FastEthernet 0" and one "Eth 0" interfaces; connecting a DSL line to our internal LAN.FastEthernet 0 interface is connected to the DSL line via ADSL modem (Zyxel) which is configured as bridge mode.Eth 0 is con...

remeshkt by Level 1
  • 1304 Views
  • 11 replies
  • 0 Helpful votes

Resolved! EEM EXPERIENCE

Did anyone has got a pratical experience around the TCL script using the EEM tools ?In the detail I have some difficult for an event that have to macth the CRC increment in an ATM interface and after trigger down that interface.Over the web and Cisco...

grupporete by Level 1
  • 2065 Views
  • 17 replies
  • 0 Helpful votes

I have got two Links through BGP n internal i am using ospf, one i am using as primary n other as backup.If the primary goes down all the traffic is going VIA backup n when it Primary link comes back, the traffic is still not getting shifted.I have t...

I'm running BGP with my own ASN, and peering to 2 providers, one 10Mbit, and the other 3Mbit. I prepend my own ASN as-path many times for the 3Mbit provider, so remote networks will almost always prefer the 10Mbit link. Ok, so now to the challenge.Th...

spacemky by Level 1
  • 1889 Views
  • 2 replies
  • 0 Helpful votes

I have a non-E 6509 chassis, and a ws-x6516-ge-tx that needs to go into slot3. The ws-x6516-ge-tx is keyed, and will not fit due to a different keying (the silver half moon guide pin is rotated) in the backplane connector. Are there different 6516 ...