Routing

Hi All, Can anyone provide me Cisco 7609 basic configuration guide,I am new to cisco router.Regards,Naveen

Dear All,Wwe have recently provided one odd customer with OSPF sham links and customer has asked to provide load-sharing on both the service providers.All CE routers are configured as AREA-0.The fallback onto SP-2 is happening but whenever we apply t...

Our stacked 3750 switch automatically shows all ports as amper color. When checked found that there is no vlan.dat file in flash. When created the vlan again everything worked well. Without any reason this happened automatically. If somebody removed ...

hi,we are using 2821 router with 1 NM-2CE1T1-PRI in slot 1 and 1 VWIC-2MFT-E1 card in HWIC 0 slot.the problem is that router is not taking the card type e1 0/card type e1 2 command.i have to configure 1 2MB link with unframed command on VWIC-2MFT-E1 ...

Does anyone know how I can setup a client vpn group to be able to terminate at an ASA and still have Internet and the ability to traverse other VPN connected sites (Hardware VPN)?Thanks

Hi,I am trying to send a default route to a CE via Radius reply attribute(Client connects to our LNS) - Is it possible?I have tried:cisco-avpair ip:route=0.0.0.0 0.0.0.0 dialer0Without success(CE connects, then disconnects repeatedly)Thanks in advanc...

Does this version on a PXI 501 support restoring the config from TFTP. I am able to save it to a TFTP with write net, but how to get it back?

We recently installed a P2P T3 circuit between two offices. We are getting a large number of input errors, CRC, overruns and carrier transitions INTO one of the sites. At the site the connection is coming from, our provider is testing clean to the ...

Greetings.I recently configured a Cisco 877W and i'm currently trying to make DynDNS work ok, so i can access from my office to my home computer.The router seems to be updating my ip correctly (if i shutdown and restart my dialer interface, or if i r...

Hi, I am using Netflow with my Cisco 1841 with DSL card. The 1841 is in VPN mode and I notice that we use Citrox on port 2598. Neflow sees Citric as TCP 1494 and UDP 1604, do I need to add ip nbar port-map citrix tcp 2598 to my config?The reason I ...

Any one have idea how to take logs from ATM card console. after logging to 10K - OC4 Interface console no command works, is there any special commands required.

Hai all,My customer is facing a issue in load balancing OSPF in Multilink (Point to Point ) after configuring the multilink customer is only able to use 60 % of the bandwidth.Now customer has removed the multilink but still he is not able to load bal...

Does anyone know if the ASA or PIX device actually support the WAAS features taht some branch office routers have?