Routing

HiCan anyone point me in the right direction to obtain performance details for using an NM-1T3/E3Can i get the full T3 45Mbps throughput using a 2811 ?Thanks-Paul

Dear All,For load balancing by using BGP we can use maximum-paths option. I want know that if we are doing BGP multihoming with different providers then maximum-paths option will remain valid or not ?Regards,Mujeeb

I was reading the Q&A for OSPF and came across the question regarding two external routes for the same destination being advertised from two different ASBRs. The answer states that the preferred routes is the one from the ASBR with the shortest path....

We will be getting a 3 M internet bandwidth connection. I installed a VWIC2 2MFT-T1/E1 WIC card on a router for being able to use the 3 M bandwidth. 1.What is the config to enable the two T1 ports to simulate 3 M bandwidth.Thanks.Said

We are currently using a Tasman router that is configured for a multimeg circuit. (Two T1's bound together) We want to use a Cisco 2600 version 12.1.9 as a backup. I asked a tech at Verizon for a configuration that could be used and he sent me one th...

I keep getting this error on my syslog server from one of my Cisco 877 VPN ADSL routers:60: Dropping TCP Segment: seq:3959461132 1420 bytes is out-of-order; expected seq:3959437672. Reason: TCP reassembly queue overflow - session 172.19.10.18:2293 ...

HI,please help am unable to log into my router using console,no ethernet ip address,how do login through the aux port are there any settings that are required.

I have recently purchased a Catalyst 6503 switch with Supervidor engine 32 and two 49 GigE blades. I have configured L3 switches before, but I am having an extrememly hard time routing my VLAN interfaces. I am even beginning to question if i did ac...

Wy CNR version 6.2.3.1 has been retired? Is it becase this version has several problems? I have an issue with this software and wonder wy I can not dowload any more this CNR version.

Hi,We have 7204 vxr router with G1 prossesing card int.When we did through output test we are only getting 210M for TCP and 820M for UDP which is realy concerns, by Cisco it should be near 512M.Any sugesstions ?Regards,sh verCisco Internetwork Operat...

HiWhich module can i use to compress data on my two 1751 routers connected via 64 k diginet line(to be upgraded).And where can i find this, i'm based in South Africa.Aubrey

Hello,I just got a wired problem this morning, and I hope someone can explain it.I connected the router to the internet,this router obtained a static ip address via PPPOA from ISP. And I was on internet...BUT there was some sites I could not open at ...

On the Physical Interface i am using Frame-Relay Encapsulation.I have created various sub-Interfaces with different DLCI values.I want to monitor traffic flowing through a particular Sub-Interface using Ip Route-Cache Flow command as we generally do ...

I'm having trouble with NAT.This works:static (Internal-201,ELI-External) tcp interface 3389 192.168.201.114 3389 netmask 255.255.255.255This doesn't:static (Internal-201,ELI-External) tcp MY_EXT_IP 3389 192.168.201.114 3389 netmask 255.255.255.255Wh...

is there a command like copy flash: tftp: without having to do every file on there without doing each individually?