Routing

Hello,I very often use the a couple of commands in the same order on our ios routers.Is there any possibility to create a macro or alias which runs then several commands.What I mean is to enter simply one alias or macro name on the cli which then run...

We have in our company 2 catalyst 4507R redanduncy(4 gigabit switch for each catalyst).The soft who permit to adminstrate it is Cisco Network Assistant version 4.0.I want to know if there is an another solution like ASDM for pix or SDM for router to ...

i replaced a server1 but used the same ip. used a different name. now i can only connect to it in my building. from switches at the other campuses, they resolve the name to the correct ip but cannot ping the ip. the router resolves and pings it fine...

hiwe are having more than 25 routers running ospf .and there are 4 different stub areas.namely 10,20,30 and 40.Routers connected to these areas are R1, R2 , R3 and R4 respectively. These are ABR. These routers are connected to other locations in stu...

Hi All,Just wanted some pointers, I need to implement a solution which requires a 45mb G.703 T3 full rate (DS3) circuit presented each end as Ethernet (layer 2). Plan is to terminate the serial DS3 circuit on two 3825's with the NM-1T3/E3 modules and...

Dear all,I have setup a Cisco 871 router configured with VPN and Internet service. My line is a 1M line and I am wondering if there is a minimum or maximum bandwidth used for VPN. When there is no traffic, how much bandwidth does a keep-alive traffic...

Hi ,I am facing problem in access share via Mac OS8.1. My network core switch comprise of following IOS version Catalyst 4500 L3 Switch Software (cat4500-ENTSERVICESK9-M), Version 12.2(31)SGA1, RELEASE SOFTWARE (fc3)and the same share is working for ...

when i boot the 1600 router """ transevier problem """"" msg shown. how am i rectify that.pls suggest.

Is is possible to set up a second ip helper address on cisco routers as a backup should the primary dhcp server be down?

Hi all, I have 2 switches connected to each other via wireless links. I am trying to balance traffic per vlan basis changing cost's of trunking interfaces, but the problem is that when the primary wireless fails the stp converges everything looks ok...

Hello,We have a 7206VXR that we've been trying to upgrade for the last two weeks to the NPE-G1 processor. After we upgrade the processor and the IOS to 12.4.11T, we experience packet loss on our DS3. The circuit provider has confirmed the packet lo...

Good morning, I'm new in Cisco forum; I need to ask about the ISL on cisco router: I would to buy a R 2610 (used) to build my lab to study for CCNA certification. I sow the answer of Inzeos781 in this forum posted Jul 4, 2007 where to configure the I...

I mentioned the problem i had until today with the speed of one leased line connection 64 Kbps. It was very slow and it was loosing packets. On both routers main and remote run two protocols . RIP v2 and EIGRP . I removed the EIGRP and the problem wa...

i have a 2811 router with (C2800NM-ADVIPSERVICESK9-M), Version 12.4(15)T. I was intending to configure this E1 card for Data but it doesn't take me to the controller interface. what might be the problem? can this vwic do data?

I am using a 7200 router with 4 fa port. 3 of which is connected to different ISP and 1 for my LAN. I tried to configure 3 multiple default routes 0.0.0.0 0.0.0.0 x.x.x.x for my three ISP but only one ISP can route to the internet.interface FastEther...