Routing

one of my customer wants a router for Primary site , currently using 2821 router in Primary site

I configured the router which are connecting to 2 different branches. But always i can see the traffic is flowing only through one link only. how can i do a load balancing. The 1st link is 128Kbs and second is 64Kbs. Is it necessay that both the link...

Standby track command it will track serial interface or Ethernet interface?

i have a 3600 series router in which i could not boot the system. it comes into rmon mode. im trying to put an ios image through xmodem but it showes me this message kindly advice me how to proceed with this upgradation, i have set the confreg to 0x2...

Hi,My question is why isn't the 1483 bridged Encapsulation method available for configuring a Router whose client has a static IP. Both myself and collegues have gone through the set up in the SDM software and can't find this option. Are we all missi...

HelloI have 4 different sites which are connected with diginet lines. When these lines go down the routers are meant to automagically open the ISDN lines and dial out to connect the site. The problem is that this has never worked before I joined the ...

When I connect the adsl cable, the CD led gives no signal.The RX/TX led's are flashing very fast.When I do a 'debug atm events', I get :Router#debug atm eventsATM events debugging is onRouter#00:18:53: DSL: 20: Modem state = 0x800:18:56: DSL: Could n...

Hi all,Here my problem I need connect to server on 2000 port its actually manageSIEVE port. Connection setup goes fine SYN->ACK SYN->ACK. When server send me first packet Router thinks its skinny fragmented packet. This packet goes into internal queu...

In HSRP ,Standby track command it will track only serial interface or Ethernet port also

EXISTING;-2 CORE SWITCH-4GBIC - PORT CHANEL 1 ON EACH CORE-PORT CHANEL 1 CONFIGURED FOR HSRPQUESTION;-for now, correct me if iam wrong, hsrp is tracking the whole port channel 1 and monitoring it as single interface. -is it possible to track if say 2...

Hi Please let me know the command to reload a single module on a CATOS switch with software cat6000-sup2k8.7-6-5.binThanks

I?m tryng to test this command but does not exist. I?m running 7206 Version 12.3(14)T7. Could anyone help-me ?R4(config-router)#bgp bestpath ?compare-routerid cost-community med

So I'm studying for my CCNA exam. I have a home lab with 2 Cisco 25141 Cisco 26111 Cisco Catalyst 2900I can configure the Ethernet ports to work with eachother perfectly, but feel that I need to practice other technologies like Frame-realy.I am havi...