Routing

I have a design question which I'd like some advice on. I have a router sitting at a hospital. This router has to connect to two different office suites via fiber. Both suites connect in the same closet and the fiber to the router is a few blocks ...

I trying to configure Cisco's 1841 router acting as gateway with NAT. I have two ISPs and each of them gives me one IP. Now I need to configure inside web and DNS servers to be accessible from outside via both ISPs addresses.I think it is possible t...

We currently have connection to two ISP.ISP A is terminated on a 1760 while ISP B is terminated on another router (2611). Both routers were connected together through a cross-over cable. ISP A has uplink bandwidth of 512k and downlink bandwidth of 2M...

This one is driving me crazy and have a TAC case on it, just have not heard back on it yet. I can only get 1.5 mbps with 831 router connected to dsl modem, but get 3 mbps or better with PC connected to same modem, has anyone seen this before? Have tr...

Hi All,i have two isp connected to my router, i have Multiple Nat pools using route maps.here is my router configip nat inside source route-map Nat interface Dialer1 overloadip nat inside source route-map Nat1 interface Dialer2 overload!route-map Nat...

I have a wireless modem & I connect it to e1/1 of 2610xm router . this modem give the dhcp address but I the e1/1 of router does not receive ip dhcp .how can I set dhcp on this interface to take dhcp address automatically.thanks

Gurus,I have an existing PIX 501, and have just purchased two more that I need to deploy to remote locations. I need the remote PIX's to VPN into the existing 'main office' PIX. There will only be one or two users behind the remote PIX's.The users wi...

Hi I have network of 2500 series router abd as backup we are useing ISDN on one of the router Cisco 2520 seriies and IOS verions 11.1(10) currently running on it.have the following config....s (plz chek) interface Serial0 backup delay 1 1 backup inte...

hi, Can anyone help me how to configure a serial interface for telco given all needed parameters such as counterpart ip address and encapsulations. Tnx

Hi,Can anyone help me how to create a dial peer voice for all kinds of codec like G729, G723, etc... Also capable for SIP and H.323 connections. Tnx

Folks, We have a Sup 720 in a 7600 series router. We want to use the 2 gig ports in it to pass traffic in our backbone(Gig). Does the architecture all users to use Sup 720 gig modules to be used for passing heavy traffic (line speed). Does the archit...

Experts,I am running into a routing issue with a dual-home BGP setup with HSRP. I have two ISPs (ISP-A & ISP-B) and I'm following the setup showed in http://www.cisco.com/en/US/partner/tech/tk365/technologies_configuration_example09186a0080093f2c.sht...