Routing

Hi All,I configured the PE and the CE as follows, but i got a lot of packet loss and a very high delay, any comments ?CE:! interface Loopback13 ip address 13.13.13.2 255.255.255.252!interface Virtual-Template1 bandwidth 2048 ip unnumbered Loo...

Hi I upgraded the Cisco ISR 2821 with IOS c2800nm-advsecurityk9-mz.124-5. My old image is c2800nm-advsecurityk9-mz.124-3a After the upgrade, I reloaded the system. After that, router is not booting up. I see the message like below:System Bootstrap, ...

Below are two different MLPPP configurations. One uses a virtual-template with ip unnumbered and the other a multilink interface with /30's. For bonding multiple T1's together from the CE to PE, what is the best method? In order to enable Qos, is the...

HiI have two location`s with 2801 and both sides have 2 isp connections to internet and site-to-site VPN connection on both the links and both locations, each link should be load balanced and act as failover in case one goes down.The links are 2 Mbps...

Dear Sirs, Please teach MTBF. Cisco 1812CISCO1812/K9Best regards,

folksi have 2 routers either side (inside and outside) of a symantec SGS firewallthe outside router connects to a third party network over a 100Mb ethernet circuitthe inside connects into my own corporate lani have the same setup replicated on a back...

Hi,I'm working for a company as a Junior NOC, basically very often I should provide the Circuit details - logon to a router with a show int sxx but I was wondering how this circuit is configured on the router, I can find any informaiton on the cisco ...

Hello, Does CAT2948G-IN-M Layer-3 Switch supports NAT command ?.Below is the IOS version running in the L3 switch.FSSswL3#sh verCisco Internetwork Operating System SoftwareIOS (tm) L3 Switch/Router Software (CAT2948G-IN-M), Version 12.0(25)W5(27) RE...

i try to look cisco site, and i don't see ios for isis on cat 3550; that 's means that cat 3550 can't operate isis protocol.Please, somebody can confirm it .Regards.

I purchased a Cisco 3845 with HSEC capability. This router should have an on onboard AIM-VPN hardware accelerator card (AIM-VPN/HPII-PLUS). I did a show version and it says there is one VPN module. What command can I execute to verify that the AIM-VP...

Hello Friends,I wanted some info on spanning done in switch here I have a situation where I want to sniff the traffic by doing port mirroring and also want that sniff traffic to forward on one of the server ...if anybody can please help with the conf...

Hi,I wonder if anyone can help. With have a Cisco 5811 using a PRI ISDN line and about every 5 or 6 hours the line will lose sync with the router leaving us with no phone lines. After a simple restart of the router everything comes back to normal.Any...

Strange problem with new 2611XM router. Have two of these with 64MB DRAM each. Need 128MB so ordered the memory upgrades. However, when installing the new memory, the system no longer sees the Fast Ethernet interfaces! The error message below is ...

Hi there, I have a network with 7 access layer switches connecting to 2 4507R switches. When i give a show standby brief on one of the core switches it gives the following output -Interface Grp Prio P State Active addr Standby addr ...