Routing

Please which ios version is required to implement vrrp on interface cable on CMTS (UBR 7111) and on ethernet interface of 3600 router ?Best regards.

Please, i have a arp fault between CMTS and the iptelephone. When i clear arp, the problem is solve and after it begins.How can i do the solve it complely ?Best regard.

I have a C837 ADSL router which I need to configure to allow people to view a website and access a Mail server which is hosted on a server on the LAN. The router is connected to the internet via an ADSL connection and has a block of 8 IP’s assigned t...

I have a central 3600 that make and receveive ISDN calls to a from several Cisco 700.Clients from 700 series LAN side use services in two servers on network (W2K (sql) and W2K3 (email)) in the 3600 series LAN side.I run Ethereal in both W2K and W2K3 ...

Hi,I have trouble for understand the concept of bgp feature: next-hop-unchanged. Could somebody give an advice or explanation to me? Even if somebody have the related link in cisco web, please show that to me. Thanks a lot.Sincerely

Hi,can anybody help me.This is very urgentIn our network there is a problem with the standby supervisor engine.So we are going to change it.Now after placing the new supervisor engine we like to upgrade the ios.The present ios running in active super...

GooddayPlease how and when i can use snashot protocol ?Every suggest will be appreciate.Thank stephane .

Hi,Can anybody tell me what does the values of config register means.0x00000x - means the one following this is a hexa decimal.0 - represents what?0 - represents what?0 - represents what?0 - represents what?An early response is really Appreciatable.R...

I have a cisco 1700 router with adsl wic. I am looking for step by step in configuring ppoe with my router beginning to end. I am looking for bellouth specific info, noit a basic config with ppoe with nat. thanxjorge

I saw some 2500 routers on eBay that are CiscoPro models. Are they the same as the regular 2500? Will the same IOS run on them?

Good dayPlease, which sofware i need to use to apply vrrp on interface e0/0 of 3600 router ?Any suggest will be appreciate.Thank stephane.

Hi,I am trying to understand that under what conditions you can see this output## show ip nat translationsPro Inside global Inside local Outside local Outside globalicmperr x.x.x.x y.y.y.y --- ---Where x.x.x.x is the address of the ou...

we are getting a DS3 without BGP for Internet to a clear channel T3 card in a 3845, with 1 GE to our LAN, 2 dual MFT1 cards to connect to 4 partner sites.the ISP config info refers to c-bit parity (as in clear channel on ATM ?), but ATM scrambling an...

I did a show version to show my ios and memory etc. here it is.Router>show versionCisco Internetwork Operating System SoftwareIOS (tm) C1700 Software (C1700-SV3Y-M), Version 12.2(4)YB, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1)Synched to technology vers...