Routing

Hi Everyone, Could someone please share their knowledge or experience to solve my configuration problem and advise about the best way. This is regarding routing configuration on our newly purchased Cisco SG350X-48P (SN: DNI23160B1Q) for customer. I h...

Hi Dears,I have Catalyst 4500 L3 Switch, I want to configure temperature threshold and send the notifications to SNMP server, I tried the commands in the attached snapshot but the router not accepting these commands.please your kind support.

so, i have 4 switches.  one switch feeds the other 3 switches that are in different locations.i have config-ed a vlan 500 with an IP of 10.30.13.0/28. enable EIGRP, etc. and attached a port to that vlan. On the remote switches, i'd like to have the r...

Collegues,I hav e the following connection scenarioVLAN 100 -С3750 -->  ASR1002-X(1) - 1270 -> ASR1002-X(2)--> C4507 -VALN 100 Could you please suggest correct way or some examples to use VLAN 100 on both switches on access ports via Q-in-Q via VLAN ...

HelloMy carrier is dropping off a single mode fiber on LC connection 10gig port but on myrouter I am using XFP-10G-MM-SR modules.  Can I still use a SMF to connect from handoff to this router or do I need a different module?

I'm planning to update an ASR 9001 from version 5.3.4 to 6.5.3 with SP3 - is it possible to do this in a single reload?  I mean, "install add" the 6.5.3 and 6.5.3-sp3 then "install activate disk0:*6.5.3*"...Thank you.

Our 7010 is on  BIOS: version 2.12.0, kickstart: version 8.2(3), system: version 8.2(3) and I'm planning to upgrade it to 8.2(5). For some reason, I don't seem to have the rest of the options available under "show install all" as I would like to test...

  i'm having a strange problem with IOS-XR and removing class-map references from policy-maps.  It does not seem to let me remove a reference to a class-map and remove the class-map in the same transaction.  Is this a bug?  I sent the commands in the...

We are in the process of moving one of our departments to a new location where we will need to create a point to point VPN tunnel using an ASA-5505 at the far end and a Palo Alto at our core location.  I am much more familiar with configuring the PA ...

Hi AllCan anyone talk to me about FEC (forward error correction) at the packet level ?I believe many SD WAN products now use this and I believe it can have really good effects on a lossy / high latency network.Does it work?How does it work?Does Vipte...

Hi all router gods I have an HA pair of ASAs that i'm trying to configure to pass a received iBGP 0.0.0.0/0 route and redistribute it into OSPF. The route is in the ASA routing table however its not being redistributed into OSPF. I suspect that I nee...

I'm relatively new to large-level networking, setting up a new vlan to be distributed on my network.I have a loop of 5 c2960x switches all connected on a 10G fiber backbone and SFP+ ports, 1&2 are stacked, the rest in a loop.                  1&2    ...