Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Hi All, I have IP SEC tunnel from hsrp peer1 and dna advantage license activated on it and peer2 activated with right to use (RTU).Ill setup IP sla from peer2 towards peer 1 and will be tracked by EEPM applet.If Peer 1 goes down, then EEPM applet wil...

I have router a with a gre tunnel (tunn 1)to router b. Gig 0/0/0 to Gig 0/0/0i need to make another tunnel from A to a third on router C. C is connected to B on gig 0/0/1. No routing protocols it’s a small network all static’s. What’s the best way to...

ColForbin by Level 1
  • 114 Views
  • 2 replies
  • 0 Helpful votes

Hi there,I am using packet tracer and I have an issue with area A talking to area B or area B to area ACloud is configured to use modem4 to Ethernet6Server has DHCP on and can talk to router and other PC in area A but not area BArea A inside IP is: 1...

maxintime by Community Member
  • 134 Views
  • 3 replies
  • 0 Helpful votes

Please refer to the picture I added. I have a situation where in ZONE1 and ZONE2 NEED to have the exact same IP address schemes. ZONE1 and ZONE2 connect to SW1 via point2point connections. The idea is that host connected to SW1 in the 10.0.0.1 need t...

mcast999 by Level 1
  • 170 Views
  • 3 replies
  • 1 Helpful votes

Hello,What do you think cisco meant by the following?"Packet switching is a method of data transmission in which a message is broken into several parts, called packets, that are sent independently, in triplicate, over whatever route is optimum for ea...

a1111 by Level 1
  • 969 Views
  • 12 replies
  • 0 Helpful votes

Hello, I have a question because the value displayed in show version after firmware update is different from the existing value. This is the equipment in question.C6509-E, Catalyst 6500 Series Supervisor Engine 2T (IOS version: s2t54-adventerprisek9-...

dae0712 by Level 1
  • 123 Views
  • 3 replies
  • 0 Helpful votes

The documentation states that unencrypted throughput is unthrottled and encrypted throughput is controlled by license. What does encrypted throughput mean in terms of the 8200 throughput license restriction? I've read the documentation and I'm still ...

emuman100 by Level 1
  • 290 Views
  • 6 replies
  • 0 Helpful votes