We're pleased to announce that AnyConnect is macOS High Sierra (10.13) compatible.
Our recommended version for High Sierra is 4.5MR2 (4.5.02033), available today 9/25/17. This version includes additional guidance to ensure that the AnyConnect Kernel Extension (KEXT) is properly approved by the end user. This is a new requirement in High Sierra.
4.4MR4 and 4.5MR1 have also been tested for High Sierra compatibility, but will provide no further guidance to the end user (beyond the single OS prompt) that manual steps are required to provide full AnyConnect capabilities. Additionally, with these older (compatible) AnyConnect releases, a reboot may be required after manually approving the AnyConnect extension to continue to run. This step is not required with 4.5MR2.
Note: Customers using Host Scan must be running version 4.3.5038 or later of the module in order to detect the presence of the macOS 10.13 firewall.
We will continue to look at any way we can optimize this experience in subsequent maintenance releases.
I have recently replaced my ASA-5506X with a Firepower 1010. I had Microsoft PPTP pass through set up on the ASA, but cannot get it running on the Firepower. I have tried to configure the VPN Client in FDM, but it says I cannot specify an inter...
we have project for both StealthWatch and ISE. Plan is to configure ISE 2.4 patch 9 to pull events through WMI from Windows Server 2016 to ISE and share it with Stealthwatch. We have problems with ISE collecting events from AD. We used Dom...
Hello,I am running two ISE 2.4 nodes in Prim Admin and Sec Admin and PSN enabled on both.I have installed patch 6, and 9 on Prim Admin and only Patch 9 on Sec Admin. As my Sec Admin was build Months later than Prim Admin so I did not install patch 6...
Hello,I have 2 ISE nodes Version 2.4, Running in Primary Admin and secondary Admin and PSN on both setup.I am running Radius, TACACS+ and Guest services.My Radius and Tacacs are working fine.2 Issues I am facing in my guest setup1.In Guest access self reg...
Hello,I am running ISE 2.4, on prim Admin I have installed patch 6, 9 but on sec Admin installed only Patch 9. because my secondary Admin was build months later so I did not install patch 6 on the same.Is there any problem??