We're pleased to announce that AnyConnect is macOS High Sierra (10.13) compatible.
Our recommended version for High Sierra is 4.5MR2 (4.5.02033), available today 9/25/17. This version includes additional guidance to ensure that the AnyConnect Kernel Extension (KEXT) is properly approved by the end user. This is a new requirement in High Sierra.
4.4MR4 and 4.5MR1 have also been tested for High Sierra compatibility, but will provide no further guidance to the end user (beyond the single OS prompt) that manual steps are required to provide full AnyConnect capabilities. Additionally, with these older (compatible) AnyConnect releases, a reboot may be required after manually approving the AnyConnect extension to continue to run. This step is not required with 4.5MR2.
Note: Customers using Host Scan must be running version 4.3.5038 or later of the module in order to detect the presence of the macOS 10.13 firewall.
We will continue to look at any way we can optimize this experience in subsequent maintenance releases.
Hi, I'm installing ISE 2.6 with Anyconnect 4.7 with ISE Posture VPN Posture and Compliance Module 4.3 for posture. But When test PC is connected to NAD, it gets authenticated but Compliance Modue shows message "Byppassing anyconnect scan your network...
Dear Support, We have FMC 2500 appliance where fiber card 10 GB is integrated.we are trying to move the management copper port , to the fiber ports 10 GB. however , if you go to system > configuration > management interfaces , you will onl...
Hello together,I normally use the Cisco AnyConnect Secure Mobility Client to connect to my university's network when I'm working from home.For some time, it hasn't been working any more. As soon as I establish a connection over the VPN client, I can not b...