Server Networking

Does anyone know what is the maximum number of mac address supported with mac access-list extended MAC_Control command in 6509?

Does anyone have experience with Cat6K design and configuration best practices for Oracle RAC?TIABill

Serial over LAN (SoL) is not working on my IBM BladeCenter, what do I have to do on the IGESM to make this work? ThanksBill

Why does my IBM BladeCenter IGESM keep loosing its IP address? Tom

Hi,I was working with a issue, in which we were observing that the citrix application page is freezing intermittently for 5-10secs and again working without any discosnnections.On troubleshooting I did nt observe any abnormal latency or packet loss o...

Hi:I have been testing a DLSW ethernet session between a mainframe IBM and a Tandem. I noticed that It gets connected after a long time, I found in my dlsw reachability table that I have the remote mac-address in the Local and remote reachability. I ...

I have a ACE loadbalance environment that when clients connects to realsever ip addresses, their connection get timed out after 1 hour of idle. How do I change this?

Is there a way or will there be a solution on how to block a specific messages before sending it to a syslog server. So far, they can be blocked by severity groups.For example, i would like to block the the following level 3 message:%CCH323-3-CALL_SE...

One of my 6500 MSFCs has a number of these virtual interfaces configured - though there are no associated interface configuration commands.I can't find any explanation about what these are for on CCO. I strongly suspect that I can delete them, but I ...

Hellowhich methode (fix,pagp or lacp) should I use with an ESX server and what other interesting point should I care about it?The customer would like to connect the ESX Server to a WS-4006 Chassis with WS-X4013 supervisor. many thanks for any inputOl...

Does anyone know whether we can bind secondary IP segment on CIP connection ?CIP card using is CX-CIP2-ECA2 (CIP2 controller (2 IBM Channel)) in Cisco 7513 router with RSP4 running IOS version 12.1(9)

I'm trying to migrate from a CIP attached router (7204) to an OSA card on our mainframe for our SNA connectivity. I've run into a bit of an odd problem. It seems I can make a connection to the MAC on the OSA card from a subnet within my data center (...

Looking to help out a developer here.Right now all pages http://pyxis.constellation.com:80/* go to a single page http://pyxis.constellation.com:8046/. We want to rewrite the URL changing the port so that http://pyxis.constellation.com:80/whatever goe...

I noticed on our switches that the ones that have CatOS on them are using the mgmt port on the supervisor engine (sc0). However, the ones running IOS are just using a port on a normal blade and is seperately configured. I was wondering, shouldnt we b...

Hello,?Someone know what Cisco product is a Load Balancer for applications and services?.Regards.