I rest my Spa508G telephone which is for restaurant.and now my line is not working it’s asking for CMS login. I don’t know username and password. It has to be in numbers too. I have 3 telephone with 3 lines.
Forum Posts
Hello,Within the past few months, we integrated SPA 303 phones within our small team. I am looking to configure 3 of these devices (as I am the admin) to monitor the status of each other. There is the following section from the user manual, however, ...
Greetings, I have some switches (CBS 250/350) with firmware 3.0.0.69, 3.1.1.7 and 3.2.0.84. I would like to know if possible from those versions to 3.5.0.26.
Hello,I've bought a Catalyst 1300 switch from Amazon and it arrived yesterday. Yay.The datasheet states:Complimentary one-year access to our Small Business Support Center for ongoing support and a limited lifetime warranty with Return-To-Factory (RTF...
Unfortunately, for a few days my Cisco ATA-122 seems to have some problems. In the face of no VoIP phone call, it receives and transmits traffic from/true internet as if it were on a phone call. Unfortunately, no conversation is taking place. On my f...
Hello, I have an old back up device NSS324 with 4 drives in it that used to be connected to a windows based office network. The office and network no longer exist but I need to obtain some files from the device, and I use a MacBookPro. Can you advise...
Hello,we have received Cisco 6825 and 6823 phones from a VoIP provider Placetel.Now we have the problem that a call waiting tone sounds during a phone call when another caller is in the queue.I have not found a description anywhere on how to disable ...
Hello, is there any disadvantage when enabling / using CISCO SMART LICENCE in connection with on-prem ESA 195 Gateways?Based on special GDRP Regulation it is sensitive in the current case.
Hi Team,MGBLX1 cannot running on C1200 cause the SFP module no have any power properly In Show interface ca'nt recognize the interface Gi25 and Gi24 is down In Log SFP present But in show fiber optical transceiver not have any power How to ...
Hi, I have an ATA 192, but the client is asking if it is possible to configure the "Shared Line" feature on this device. The datasheet does not mention it, so I need to know if it is possible, and if so, could I get a document confirming this?
Hi guys. I have a question regarding the Small Business license for FPR1010. According to the attached documentation, when purchasing the FPR1010T-SBE-L license, the customer is entitled to device management via CDO. To our surprise, apparently, to m...
Hello,I'm trying to connect to MMB on Cisco C880 M4 chassi via com port and been following the manual instructions. I want to start configuring the chassi initially to later instead use the web gui. I'm unable to get anywhere as I get no response in ...
craigaredpath Community Member07-28-2024 03:01 PM I'm supporting a site with new Cisco CBS switches - Replacing a lot of old 2960's for the business switches. I use netmiko to gather port information from the switches and then display it on a web pa...
Cisco ASA question2 Questions:1-why cant i see interface eth1/2 and 1/3 in output?2-Also, how to find out which ports are part of port-channel?fw# show int ip briefInterface IP-Address OK? Method Status ProtocolInternal-Data0/0 unassigned YES unset u...
Hii Please I need to know how to go about renewing smartnet license for a Cisco device, both as a customer and as a partner. Thank you.