Storage Networking

Hi ,As soon as I logged into 9124 CLI I found error ( may be warning)messages as below:2011 Jul 22 08:02:27 <Switchname> %AUTHPRIV-2-SYSTEM_MSG: stdin not a tty2011 Jul 22 08:02:37 <Switchname>%AUTHPRIV-2-SYSTEM_MSG: stdin not a tty2011 Jul 22 08:02:...

Hi all.i am Supporting for Storage.i am working on SAN cisco switches.i am intersted in doing cisco certification on MDS switches.can anybody help me how to get latest dumps for reference.i aleady have CCNA certification.will it be useful...

Hi,While creating Zone , Do we need to create two zones for Two HBA for a host connected with SAN ? Or a zone is enough for a host which having Two HBAs...We have two 9124s for our SAN fabric...As I found like one zone  below, I little bit confused t...

HI,Please send me the document link where i can get the details of CisCO SAN FC switches family from Begining to till date and there firmware version details available.thanksKishor

Hi,Please send me the steps or procedure how to capture the CISCO SAN Switches error logs or logs and also send the best steps how to analyze the same.Since whenever i will see some issues in switches am not able to see those log details or am not ab...

HelloI have recently upgraded from Fabric Manager 3.3(2b) to 4.2(7b). I followed the correct path, so went from 3.3 to 4.1 and then from 4.1 to 4.2.The application opens but I can not browse to the localhost address on either http or https and there ...

Hello,I'm presently designing a VMware ESX 4.0 deployment and integrating it with our Cisco environment.  I've found the following document:http://www.cisco.com/en/US/docs/solutions/Enterprise/Data_Center/vmware/VMware.html "VMware Infrastructure 3 i...

Greetings all,Been trying to get a MDS 9216a to boot properly from loader prompt. Searching the forums I found a posting looked like it would work. Using 2 different SAN-OS versions "2.1.2d" & "3.3.5b", I get the following:Loader>ip address <ip addre...

Hi, Cisco Guru:Can some of you show me what is the MDS Design Guide? I want to hear from Cisco what is the recommended MDS Design Guideline if I have 2 Fabric Interconnects, 2 MDS 9513, and I am using M81KR in UCS Blades hooking up to EMC CLARiiON?I ...

Hi All,I experienced connection error as attached picture, when I try to connect to fabric manager.Can you point me what direction to slove the problem?Thank you,Dennis

Hello,After creating a VFC interface, I am binding it to Ethernet MAC-Address of the CNA. On the wireshark trace it is observed that the initiator is sending a VLAN request but there is no response from the switch hence no FLOGI is seen.Although when...

Hey all,I'm hoping someone can help me with this. I have two 9124's Im trying to connect to each other. One is a 9124blade in a HP c7000 chassis and the other is a standalone 9124. I have 4 ports configured on each switch in a port channel with port ...