We are looking at upgrading our 9513s from v3.2.2c to 4.1.3a. The upgrade procedures in the docs look quite straightforward. Has anyone experienced any issues/glitches during the upgrade ?Thanks,Girish
I'm looking into a design at the moment based on Cisco 9513. Am I right in thinking that to achieve the 192G full duplex bandwidth per slot I need to have 2 Fabric-2 modules and run them active/active ? If that is the case what happens if one of them...
Hello,I have several Clariion connected to a MDS 9509 running SANOS 3.3.1c.From Fabric Manager I ran the end to end connectivity tool against a zone-set.After the tool ran, I received several warning from my Clariion regarding initiators logged in bu...
Hi All,Is there any Weekly/Monthly New Product Launch (NPI) sessions or tech-talk from Cisco to discuss about any known current issues/Best Practices ..?Regards,KK
Issue on Cisco Device Manager:Community column list is showing blank but able to see the Role column.Able to see the Community name from CLI.Able to add/Delete Community from CLI.If I try Add/Delete Community from GUI, getting the error "permission d...
I am pretty confuse about Cisco MDS trial license. I have found Cisco documents that states that Cisco switches comes with trial licenses and 120 days grace period.I want to enable IVR (ENTERPRISE_PKG) in a switch that never used that, but the commma...
Dear All,I have 2 ciso MDS 9513 switches and have ISL enabled between those.I want to restrict 1 VSAN traffic to pass through that ISL,i know i can do it through DM by configuring the port properties to Allow VSAN's,but not sure whether this can be d...
Hi all,Our site is running a MDS switch combination of 9216's and 9120's with 3.1(1) firmware. I have just received some new gear to replace the 9216's, two 9222i's and two 9216a's and would like to upgrade the firmware on my whole fleet. What too? ...
Hi I am implementing FCIP on two 9222i MDS switches, do I need to have SAN_EXTN_OVER_IP license? because during the installation I get the message I need this license. But now I see everything running normal and there is no information that SAN_EXTN...
Hi,I have installed Fabric Manager Server v3.2(2c) using the Oracle DB option. Backup of this DB can be done in either Online (ARCHIVELOG mode) or offline (NOARCHIVELOG mode). In one of the ccokbooks i found the Oracle DB holds inventory, fabric conf...
Hi,We have a task of replacing an existing 32-port FC module with a 48-port one in an MDS 9216i switch. Is there any special procedure/commands for removing and installing a module in a live switch? I cannot find any in the manuals.Thanks
