Storage Networking

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Save 25% on Day-2 Operations Add-On License

 

Forum Posts

Hi.In DCNM (version 10.4), network SAN MDS9710, when I go Dashboard/Compute and select a host, DCNM show topology:<host> and traffic:<host>.  I wish to know what is meaning "NaN TB" in graphical traffic and how can I modify this parameters. I looked ...

Hi,I am trying to find an Cisco NS-OX command that will disable the switch that is equivalent to the brcd FOS switchdisable , but I cannot seem to find anything yet for an NS-OX command.Reason i need this is to test and prove redundancy between fabri...

JMACD40 by Level 1
  • 1428 Views
  • 2 replies
  • 0 Helpful votes

Hi Team, I have a simple question I have a requirement to connect a new storage array to a NPV switch as the ports on NPIV switch are exhausted. so can I connect the Storage array to the NPV switch and what would be the traffic flow from the hosts to...

dganta by Level 1
  • 814 Views
  • 1 replies
  • 0 Helpful votes

Hi Team, We are using Nexus5548UP where ports 1-19 are ethernet and ports 20-32 are for FC now I want to use 2 additional ports for FC now my question is, can I use ports 14-15 for FC or is it a rule that the FC ports have to be contiguous as such I ...

dganta by Level 1
  • 939 Views
  • 2 replies
  • 0 Helpful votes

Resolved! N5K FCOE and FC

Hi –I hope someone can advise me on the below Current setup: Two N5k connected with VPC, running FCoE ,vlan 21 on Nexus A and vlan 22 Nexus B for the storage.Nexus Avlan 21fcoe vsan 21name VSAN-21activate zoneset vsan 21vlan 22fcoe vsan 22name VSAN-2...

alok_doon by Level 1
  • 1048 Views
  • 2 replies
  • 0 Helpful votes

I'm experiencing an issue on a single VLAN (Vlan80) where if i have any type of deny before 'permit ip any any' the latency jumps from 1ms to ~150ms for a ping and the network goes to a crawl.interface Vlan80 description Work Network 172.16.80.0/20 i...

What native Fibre Channel technology facilitates connecting multiple Fibre Channel devices behind a singleFC address?A. Fiber Channel over EthernetB. N-Port VirtualizationC. Fibre Channel Arbitrary LoopD. N-Port Identification Virtualization

Hello,Can someone clarify the following about HyperFlex HX220c node1/ What is the purpose of the housekeeping drive ( also refered to as System/log drive) ?2/ On what drive ESXi is installed ( housekeeping, capacity..) ?3/ On what drive DPC VM is ins...

AirBorn by Level 1
  • 1115 Views
  • 3 replies
  • 0 Helpful votes

I am trying to run a Hyperflex command to get some info I was able to run some commands on the Web CLI but I need to run these 2 commands. How do I login to the controller or springpath and get the info? cat /var/log/springpath/diskslotmap-v2.txtsysm...

Dear All :        I'm recovering the Nexus 9372PX from "Loader " mode . But after finished upload the nx-os . It's prompt the image signature verification failed . I had verify the image checksum was correct . But still fail .        Does anyone meet...

ted_wen by Level 1
  • 11662 Views
  • 6 replies
  • 0 Helpful votes

Hi, Trying to setup an F port port-channel to a upstream Nexus UCS and following the documentation I need to apply the rate-mode shared to the interfaces that will participate in the port-channel, however when I run the configuration command in inter...

R.J by Level 1
  • 806 Views
  • 0 replies
  • 0 Helpful votes