Hi,I need to configure a QoS Policy for FCIP traffic going over 1GB circuits between three 6509's at three sites and then at each site at the core to distribution layer.I am hoping that the QoS policy can allow the FCIP traffic the majority of the ba...
Assisting our storage guys with some 9148s. We did a software upgrade from 5.0.1a to 5.2.8d. Now we do not see cdp adverts from the mgmt0 interface of the 9148s. Doing a sho cdp traffic int mgmt0 shows that the 9148s aren't even sending them, even th...
Just see anyone have the experience on deploying the Cisco Nexus using Fiber Channel to connect to the Storage, after rebooting the Cisco Nexus, we found that some of the ports are down or no traffic. the solution is to perform a shutdown and no shut...
I want to upgrade mds 9509 from SAN-OS 3.1.x to 3.3.5b.I can not use 'install all' so how can I upgrade the two supervisor (active and HA-standby) in another way?
Hi Guyz,I have a pair of nexus 5548UP with expansion module N55-M16UP. both switches have below licensing.Feature Ins Lic Status Expiry Date Comments Count---------------------------------------...
Hi,I have a Cisco 9148 switch, from which one port goes to "Error Disable" state even after shut-noshut. This port is connected to my storageFollowing are the details of the switch and Config.Software BIOS: version 1.0.21 loader: version N...
Hi,I have a Cisco MDS 910 series switch, where I need to configure LDAP.I have configured following steps :ldap-server host Server_IP rootDN "CN=abc,CN=as,DC=xyz,DC=co,DC=in" ldap-server host Server_IP enable-sslBut still I'm not able to authenticat...
I have 2 Nexus 7000 and 2 Nexus 5000 which connect to FI and the UCS. What I am doing is we purchased the APC racks that allow for able management for the Nexus 7000. I am making the move in a couple step process in order for the least amount of dow...
I have a client who is unable to see any performance data in DCNM WebClient (under Performance) for NPV Links which are defined/populated in Inventory. They show up there and the configuration seems to have been done correctly for flows, collections,...
I can create the san port channel using UCS manager. But I would like to know the syntax using CLI. So far I was able to figure out the following. One thing missing was moving the port channel from the default VSAN(1) to a different VSAN i.e VSAN 10 ...
Hello guys,does Smart Zoning support FC aliases ? I enabled Smart Zoning on a brand new VSAN, created two fc aliases and when i try to add them to a zone, the minute i select FC-Alias ..device type is no longer availableSwitch: 9513NX-OS: 5.2.8Thanks
Hi All, Customer noted the following message on an MDS 9148 as follows: 'zone: num_tlv greater than 1, num_tlv is 120434' Switch is running NX-OS 5.2.2d Thanks and rgds, ...
