Switches - Small Business - Page 363

Looking for support docs and videos? Check here

We recently announced the release of our self-serve virtual assistant. You can read the full announcement here. Videos and documents are available within a click for our latest products. Once you've told the bot what device you're using, the context ...

Helpful support links - Updated September 2023 w/ Catalyst 1200 - 1300

(Updated September 2023 - Added Catalyst 1200 and Catalyst 1300 ) Hello! This sticky-post will serve as a sign-post for incoming community members. Below you will find links to pages that you may find helpful. Catalyst 1200 & 1300 Hardware Install...

Resolved! what differs between sd208t and sf90d

Hello, Good Day. I need to ask if what is the main difference between an SD208T and SF90D. Aside from the price in which SF90D cost lower than that of the SD208T and that SF90D has replaced the SD208T, what else does these two differs?Thanks.

Cisco SG300 Port Authentication 802.1x no Logon Servers Available

Hi, I have configured a Microsoft Server 2008 R2 with Radius Server and connect it with a Cisco SG300 Switch.If a new device connect to the switch it goes automatically to the guestnet. If a device with the correct certificate and a valid useraccount...

MAC Address Problem on SGE2010

I have 10 SGE2010 switches. There is a stack of 4 PoE switches that is the L3 core. There is another stack of 4 data only switches. And another stack of 2 PoE switches. The 4 and 2 switch stacks connect back to the 4 switch core stack via single ethe...

SGE2010P ring of 4 switches reports one "link down"

Any help appreciated. I called Cisco Support but they didn't have an answer.We have 4 SGE2010P switches in a ring using ports 24 and 48 to connect. All are same hardware and firmware and the stack is working nicely.Problem is - System - System Manage...

QoS in Cisco unmanaged switch

I am looking for information about QoS on the 100 series unmanaged swtches. I am interested in 24-port switches and I have found that such switches provides 4 egress queues with scheduling: "Priority queuing and weighted round-robin (WRR)". I could n...

L3 ARP table size in sg300-24?

Hi folks,This is a bit of an odd question because it's about a problem I ran into a year or so ago, but I wasn't aware of these forums at the time, so I thought I'd run it past you all. Unfortunately that means I can't reproduce the problem right now...

Resolved! Port mirroring limit on SGE2010?

I have been told there is a limit (8) on the number of source ports that can be mirrored to a given destination port. I can find no specifications or other documentation to corroborate this claim. Does anyone have any factual data to confirm or refut...

Unsure of proper configuration for SF300-24 & router

Hello,Our company lost a switch and replaced it with a SF300-24. The other components are a Westell modem and an Amped Wireless R10000G router.The current configuration has the Westell DLS modem going into the R10000G router, the router is the DHCP ...

Cisco SLM2008 filters out DHCP Discover

Hello all,I'm new on this site and I came here for help with my SLM2008 switches. I've been trying to solve the problem for quite a while, but so far I was unable to solve it. So here it is:I'm trying to send IP TV from ADSL box (ak...

Resolved! LAG/LACP with Multiple VLANS

Hi there,I have two SG-200-50 switches. I have created three VLANS on one and set the same up on the other - there is no requirement for routing between the VLANS. However, I would like to trunk between the VLANS using LAG with LACP. For example Swit...

SF300-24p Q-in-Q - Changing from vlan 4095

I have a Cisco SF300-24P deployed at a customer prem running only a couple VLAN's - 1 customer related and 1 for management. Recently the customer inquired about changing his connection to Q-in-Q. I have changed the interface type to customer but t...

Cisco SG-300 network design floorer

Dear fellow techies and Cisco specialists,From a learning prespective I’ve accepted the challenge to design someone’s SB/Home hybrid network using an Cisco RV-180 and Cisco SG-300. I’m now preparing a setup for when I’ll be on-site to migratie from t...

SG500 RSPAN

Is it possibler to configure rspan?Source ports from different switches?

Resolved! How to reset pasword

Hello,I have been asked to do a network survey at a client. They are using the Cisco SGE2000 switch, which is new to me (used to working with 3750 switches).They seem to have lost the username/pasword for one the switches. Is there an way to recover ...

Resolved! Cisco SG300 / ASA 5505 intervlan routing issue

Dear AllI have an issue with correctly configuring sg300 layer 3 switch behind ASA 5505 (incl Security Plus License)The setup is as follows:CISCO SG300 is configured as a Layer 3 SwitchNative VLAN 1: ip address 192.168.1.254, default route (inside in...

Switches - Small Business

Forum Posts

Looking for support docs and videos? Check here

Helpful support links - Updated September 2023 w/ Catalyst 1200 - 1300

Resolved! what differs between sd208t and sf90d

Cisco SG300 Port Authentication 802.1x no Logon Servers Available

MAC Address Problem on SGE2010

SGE2010P ring of 4 switches reports one "link down"

QoS in Cisco unmanaged switch

L3 ARP table size in sg300-24?

Resolved! Port mirroring limit on SGE2010?

Unsure of proper configuration for SF300-24 & router

Cisco SLM2008 filters out DHCP Discover

Resolved! LAG/LACP with Multiple VLANS

SF300-24p Q-in-Q - Changing from vlan 4095

Cisco SG-300 network design floorer

SG500 RSPAN

Resolved! How to reset pasword

Resolved! Cisco SG300 / ASA 5505 intervlan routing issue

Congratulations to the Event Top Contributors Class of 2024!

Cisco + Splunk: It's a new day for your data.

A new chapter of the Spotlight Award begins!

Join us in Celebrating the New Year and the Nov.-Jan. Winners!

Announcing Resources That Guide You to Success

Cisco Business Product Family

Cisco Switching Product Family

Failed to read FPGA then Reboots

CBS 250 EoL

SG350-10P in boot loop - Serial number and HW version missing?

350-10P cannot boot anymore

CBS250-8T-D: switchport customer and switchport general