Switches - Small Business

Hi, i just got a sf300 and i need to break down my network to create different subnets.actually i am using the 192.168.1.0 /24 subnet.what i need to do is to subnet my network so that the different vlan cannot talk to each other.for e.gvlan 2 is data...

As described in older archived thread, is there any resolution or progress on this issue?Issue that I'm having is the same as somebody else had, quoted below:"The network is up and appears fine, but when I make any physical port  changes (unplug one ...

Hello.... I finished upgrading  6 SFE2000P Switches to software version 3.0.1.0, however I do not see any information about the boot version. The switches now have 1.0.0.05 and the one that came bundled with software upgrade 3.0.0.16 and 3.0.0.17 is ...

Hi,I am unable to successfully authenticate my SG200 to either a Cisco ACS or Windows2008 RADUIS server. (C3750x on the same network authenticates fine).Q1. Is this feature (management login authentication to a RADIUS server) supported on the SG200?Q...

Hey guys!I own a Sg200-08 and everytime when I transfer a lot of data via the switch it crashs when around of 100GB. Crash means it will stop working until I disconect power and reconect again.I've checked it back with a Netgear 8port device, this wo...

hi all we have a production network that uses five SG300 switches that functions brilliantly most of the time. four of our switches run in layer 2 mode and the last switch runs in layer 3 as it is used to route our 7 vlans as well as routing traffic ...

Hi,SG300-10   mode:layer 3dns server:192.168.2.11vlan1    192.168.2.0       ip:192.168.2.254    0.0.0.0 next hop 192.168.2.3vlan2     192.168.50.0     ip:192.168.50.254 dns server table:192.168.2.11 (active)Router(192.168.2.3)    dst.address 192.168....

We have a customer who is replacing older Dell switches with Cisco SG300-52s.  On one of the SG's they'll need 6 ports reserved on a VLAN for public Internet IPs (the 100Base-T uplink to the data center's Cisco switch as well as multiple Cisco ASA's ...

I have been using SRW series to setup VOIP phones in a flat network without creating a separate vLan. This works well because i can add and remove up to 48 port into port mirroring. Unfortunately the new models only support 8 port mirroring. This is ...

Scenario:I have a network that consists of the following:Internet -> Comcast modem -> Linksys RVS4000 router -> 2 x Linksys SRW2048 switches -> LAN connected devices.IssueOne of the switches is really slow at handing traffic regardless of how many po...

I am trying to setup up an LAG with LACP between the switch and a Synology DS1511+. Every time I enable LACP on the LAG I cannot get the ports to become Active Members. Any help would be much appreciated! Thank you!

HiBrand new SG300-20, every now and then on console12-Nov-2011 23:35:33 :%HAL_config_phy-I-CHNGCOMBOMEDIA: Media changed from copper media to fiber media (Unknown) on port gi19.12-Nov-2011 23:35:33 :%HAL_config_phy-I-CHNGCOMBOMEDIA: Media changed fro...

I'm completely new to VLANs, and I have a client who has a SG300-20 switch. This location is basically a shared office space with individual offices inside a large building. Each office has network ports that lead back to a patch panel, which then is...