Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Hello, Cisco Community!I’m really happy to share that I’ll be hosting the Cisco Community Lab Series, a brand-new hands-on learning journey designed to help you build practical networking skills step by step.Every Thursday at 8 PM EST, I’ll post a ne...

Hi Folks, I have 2 routers and 2 Laptops. An 1841 and 887 Cisco Router. As per the attached diagram, I have the following config: Config (887) - 192.168.0.0/24:Router(config): vlan 10Router(vlan 10): inter vlan 10Router(vlan-if): ip address 192.168.0...

It looks like the Catalyst 9300 supports WCCP v2 to some extent since there is a CLI command reference to it, but nothing in the configuration guides.   My question(s) are (assuming the Cat9300 does support WCCP v2):   1 - Are there any limitations o...

sld by Level 1
  • 1329 Views
  • 2 replies
  • 0 Helpful votes

revious we were taught to switch when we can and route when we have to. Now a days I understand with fast L3 switches we can route on the fly.   So in my small LAN of (9) 3850's with a 3850-24XS as the core router I want to abandon L2 VLANS and put m...

sw43 by Level 1
  • 1258 Views
  • 3 replies
  • 0 Helpful votes

Hi, i have migrated the configuration from C3750 to cat9300 and i want to configure below configuration under the interface " power inline consumption  8000" but this command not supported , what is the equivalent command on Cat9300. Thanks 

Steev112 by Level 1
  • 1488 Views
  • 2 replies
  • 0 Helpful votes

Dear Expert, Kindly i want to Install fiber converters between two switch WS-C2960CX-8PC-L V03 and WS-C2960S-48FPS-L V04 The fiber converters are TrendNet Convertor 10/100 Mb/s SC fiber connector to RJ45, Multimode and the WS-C2960CX-8PC-L V03 Ports ...

Hi   I am migrating our core switches next weekend and was looking for some advice on the actual move itself.   I am moving our current Cisco core stack to a new core stack. I am keeping the same IP address and using the same rack space. The core swi...

Mattys_1 by Level 1
  • 8252 Views
  • 13 replies
  • 0 Helpful votes

Hi Gents, Is it possible to have multiple IP's in same Vlan? Like i have a network 192.168.2.0/25. I have Sales and Admin dept. I would like to subnet 192.168.2.0 and 192.168.2.128. Now under the Sales VLAN, if i need to add multiple host IP address,...