Switching

Hello,An easy question... What is the difference between these three reload modes ?- reload - reload all- reload power-cycleThank you...RegardsJu

Hi All, I have small doubt... When we use ROMMON mode for password recovery we entered into ROMMON mode and the we change configuration register value to 0x2142. Post this we will reset the router. when router again boots up we will enter into a fres...

Hi all, Please find the below sh run of three router. ROUTER R1 connect to R3 & R3 connect R2 -- but i can't ping to 20.20.20.1 from R1 using source 10.10.10.1 vice versa  for R2. R1:interface FastEthernet0/0 ip address 192.168.1.1 255.255.255.252 du...

Hello, Daily we are getting high CPU utilization logs on our Cisco 3750 Switch, Kindly find below logs and provided solution for that.... If you required any other output please let us know.... Jul 9 03:00:16.190 IST: %SYS-1-CPUFALLINGTHRESHOLD: Th...

Hi,  I am looking for document/info cisco WS-C4500X-16 power consumption. Thanks for your help. Nyi 

hi community, we have a setup with 2 x Cisco 3850 IOS XE 16.3.3 with active - standby hot redundancy states (connected via stack cables). the 3850 stack has an etherchannel uplink to a Cisco 2960x access switch stack. during UAT, when powering off th...

Hi all. Not sure if this is possible but can you create redundancy in the same LAN environment? e.g. client has two core switch connected to each other via fibre in two separate rooms on same site. All switches are in same subnet. The servers are al...

Hi Guys, May i ask does Cisco switch support Radius MSCHAPv2/MSCHAP authentication as i can login my switch though PAP only? Thanks for your help!! Best regards, Dave

I have a problem with cisco FI 6324 and MDS 9148S, the MDS did no see any wwwn. the mds is configured in NPIV mode the MDS have a vsan created (Vsan 99) the fi have 2 vhba configured in VSAN 99,100 the fi fc ports are in uplink mode trunk port has b...

Hello, I am attempting to join a two separate networks together to allow my works VOIP system to travel along both networks, while keeping each network separate from each other. Network 1, static network, has the PBX on it that I need to allow acces...

Hi, We would like to verify that jumbo frames are enabled and MTU size is to 9216, for all Layer 2 switches in our data center.  QUESTION: Is there anyway to set the interface MTU to 9216 bytes?? We have run the following commands: 1.    # show  ru...