Switching

Hi All,We have an access 3750 switch connect to the 7K nexus Core - we can putty to it and ping it from other access Cisco switches but we cannot ping it from my PC or from any Server.what tools or commands we can run from the PC or the switch itself...

HI I have a router configure as BGP. there is a trunk port G1/0/12, with vlan 101 as management subent (without routing) and vlan 1234 as route subnet to route xxx.xxx.203.0/24 to routerA.now,I would like to make vlan 101 as route subnet and only rou...

I need to copy the running config from a text file to a new switch (nexus 3048). Can i just copy and paste in Putty or Hyper Terminal (after entering configure-terminal)? Or is there a specifc command I need to use?

Hi,any advices what to do if all RAM of the RP is consumed?------------------------------------------------------------------------------------------r1-core#show logSep 17 03:38:13.999 CET: %OSPF-5-ADJCHG: Process 8877, Nbr 10.100.205.246 on Vlan60 f...

i am getting the following error on our N5k. has anyone else had the same problem or knows what the error means? %NETSTACK-3-IP_INTERNAL_ERROR:  netstack [3464]Thanks

Dear Team, Anyone have the experience for monitor the vlan traffic across 2 Nexus 6k switches? My scenario are 1 of the monitor server are direct attached to the 1st unit of N6k intend to monitor 2 vlans, but this 2 vlans are span across vPC where it...

I have a point-to-point 100 Mbps circuit that I use to route traffic between a 6506 in Covina, CA and a 3850 stack in Raleigh, NC. The performance of VDI terminals in NC connecting to CA has been poor.  I used iperf to check the bandwidth for a singl...

I've got a 3825 setup on my home network and everything is working except for my company provided Avaya VPN phone. Previously I had used the old style CBAC firewall and it worked fine - once I put a rule in to allow inbound ESP traffic. I can't figur...

Hello Guys,  Is it possible to apply the configuration and execute at certain time just like Alcatel devices? if yes how ? Device model = WS-C3560V2-48PS-S (Switch)

We have a Cisco 2911 router. We installed a EHWIC-4ESG module and configured the router based on configuration below.ROM: System Bootstrap, Version 15.0(1r)M9, RELEASE SOFTWARE (fc1)System image file is "flash0:c2900-universalk9-mz.SPA.151-4.M1.bin"C...

Internet Router--->3550 Switch-->Nortel Contivity63.169.164.134-->63.169.164.140--> 63.169.140.136 All the devices are having public IP addresses and are in Vlan 100.Sometimes the Internet Router is not able to ping or connect to the Contivity where ...

I add some new switches in the cisco network assistant.but some 2960-X are showing device not supported.only 2 3560X are showing up.what is required for the 2960-X to show supported?