Switching

HiCan anybody provide me a IOS for for GNS3 simulator, which i wanted to practice some routing & switching commands to study for icnd2.RgdsAshoka

Anyone knows the answer that we upgrade IOS and replaced module for 6509 but after that DLSW circuit is not being established. The connection is like We have router --> router  (Remote and local dlsw peer) then go to switch 6509 (which we replaced mo...

I have bought a new 1921 router (IOS :C1900-UNIVERSALK9-M), Version 15.1(4)M4) and connect my ADSL link to it. After router connection i am facing frequent disconnection during uploading any file through coreFTP though i haven't face any problem in d...

Device:  asr9kSoftware: 4.2.1show mrib route.........(11.0.3.18,225.0.15.175) RPF nbr: 11.0.3.18 Flags:  Up: 13:16:35  Incoming Interface List    GigabitEthernet0/1/0/10.100 Flags: A, Up: 13:16:35(11.0.3.18,225.0.15.176) RPF nbr: 11.0.3.18 Flags:  Up...

Hello Team,We are reciving this log message in the some our ME3750 switches, but switche is working fine. Is there any way to stop this logs, we already have lot of ME3750 switches running with single power...Our client wants to stop this..Below is t...

            I am setting up LACP links to a HP c7000 blade enclosure and am seeing something I have never seen before...  I configure two 10Gb interfaces to be members of "channel-group 10 mode active" and then configure the specific trunk info under...

Hello Team,We are reciving this log message in the some our ME3750 switches, but switche is working fine. Is there any way to stop this logs, we already have lot of ME3750 switches running with single power...Our client wants to stop this..Below is t...

Hi Guys, I'm trying to connect 1 ASR router to two switches via fiber ethernet for failover.Essentially, i want to use two interfaces, 1 ip address, and split each connection between two switches so the router is still reachable if one switch goes do...

I'm using Packet Tracer for testing since I don't have the actual equipment. I have configured etherchannel between two 2960 Switches. I have used the trunk ports FE  0/23 and FE 0/24 on both switches to create the etherchanel. I have connected one P...

Hi, I'm hoping this is a relatively straight forward question for a routing expert but I'm falling over with OSPF at the moment! Essentially this is the config I have in a Nexus switch:ip route 10.50.48.0/22 10.50.33.254ip route 4.2.2.1/32 10.50.33....

hi there,any idea how to solve this problem:internet --- router -- PA-network -- asa --- intranetour provider assigned PA address space (addresses from his range). I want to migrate to PI address space (our "own" public addresses) but keep the PA add...