Switching

Hello,I use the tool "rancid" to backup switches 3750 on my network. Rancid uses the commands show run and write terminal.My problem is that for some area I dont have rights to write . I'm only a user level 7 (privilege 7) outside the command show r...

Hi,I am wondering why our 3750's CPU process increased above 90% after enabling HSRP. It used to be a single SVI until it was converted to HSRP. Can you please help me identify the problem? Thanks in advance.John

I have 3550 with single vlan running with covering 5 ports likevlan 3=ip 192.168.12.3it connects my servers in same address group.Now I want another vlan using 1 port likevlan 4:ip 172.56.2.1I want my server(192.168.12.*) can access 172.56.2.* series...

I have a network with one 4500 series switch and around 9 3750 switches connected to the main location via fiber in a ring. I am looking for good preferably free utility to monitor bandwidth and events on these switches. Any suggestions?

Hi:Before the advent of ISR routers, to perform inter-vlan routing, we used to use the so-called router-on-a-stick (ROS) config.Is there a point in continuing to do so when you have a router, like a 7600, that allows SVIs to be configured and for int...

I need to do a remote network audit for a customer's switch environment(65xx/45xx/37xx/35xx/29xx) to find out what kind of transceiver(GBIC/SFP) and cable(fiber/copper) are connected to each interface of the switch. Is there such a command to do it? ...

Hi, I would like to know if this can be done. If my packets on R1 are marked, I do no marking on R2 and when it reaches R3, I match these DSCP markings via CBWFQ with bandwidth statements for classes that I have defined.R1 -- R2 --R3. The...

I am trying to set a frame relay lab so I can create the cloud and proceed with my BCSI exam training. I have 2 x 2610 with 2 serial interfaces1 x 2510 w/ 2 serial interfaces 2 x 2900 XL switchesPlease help Thanks

I want to enable SSH on virtual terminal line (Line vty ) and at the same time keep option of authentication via line password is there some way out

Hi,I am configuring CISCO 3560 Switch with IOS version 12.2 (25r). I haveconfigured the followinglogging onlogging monitor informationalterminal monitoraccess-list 101 deny ip any any logBut in my telnet session I am not getting any log information ...

Hi, I'm trying to configure Netflow on 2 router interfaces. I configure the first one, but when I add the commands to configure the second one the command for the first one dissapears. This is the configuration: !Interface Fastethernet0/0 ip address ...