Switching

GuysAt present I use OP Manager to monitor my LAN. Sadly at present we have a very flat LAN in a single VLAN. I am looking at splitting up the LAN into multiple VLANs. I can easily route between the VLANs this has been tested. What I would like to do...

After upgrading a test swicth C2960-48TC-L from 12.2(46)SE to 12.2(50)SE I do have no port status anymore in the CISCO Network Assistent. All port are marked blue.Here are the slices of my running config:version 12.2no service padservice timestamps ...

Hi, I have a design question for my new inter-campus site. We recently build out a new site and made it a point to point connection back to my core network. My issues is rolling out my current Guest network to it. We currently have the Guest network...

I am running the following:isco IOS Software, C2960 Software (C2960-LANBASE-M), Version 12.2(35)SE5and I am unable to define static routes?I thought ip routing is enabled by default.Any idea?

Is it possible to reconfigure the 2950 DC version with an AC power supply module?

HiI have been given the task to setup our network at our new offices! Luckily I have never done something like this before!We have about 80 users/devices that will connect to our main router.We have 3 floors and on each floor there must be a switch t...

I have a multi site Metro Ethernet Service, and am currently using a 3560 series router at each site. The metro service will not honor any QoS markings so I am attempting to set up my service so that I don't send more traffic to the providor than the...

Hi all, Am I right in saying L2 switches still have a CPU ? how can multicast IGMP snooping affect the cpu ?

Hi allcan anyone explain the below, and what each one is used for, i hardly see dynamic ports used on my pc, I thought any initiated connection would used dymanic, but according to the iana, it doesnt start until 49152please helpCarlregisteredwell kn...

Hi - I have a cisco c4948 switch using the 12.2(50)SG software. I am wondering how to set up the routing between two VLANs in the CLI. Thanks, Dustin

We have two switches Switch "A" is cisco 4510 switch and Switch "B" is 3550 switch. We are trying to make communications between two different Vlans IPs.for eg :- We have created Vlan 850 on Switch"A" configured with IP and at Other Switch (Switc"...

hi allcan anyone tell me what would be normal pps on switch port, and what would be classed as high pps ? also how many pps can the average switch process, ie the c2960 ?

Any guaranteed bandwidth offered on an Ethernet-based network can only be provisioned through the cooperative benevolence granted by a lot of parties that are involved, due to Ethernet's hierarchical nature, thus making Ethernet an inexact science, s...

Does anyone have an idea or an explanation what the considerations behind the autoqos settings of the thresholds were? It is very unclear to me.Any hint is appreciated.Matmls qos queue-set output 1 threshold 1 138 138 92 138mls qos queue-set output 1...