Switching

Eigrp redistributing OSPFI have two problems here.One is redistribution of OSPF into EIGRP. Redistribution seems to work fine, my redistributing router has all of the OSPF domain routes in it's topology table. It does not seem to advertise these ro...

Hello,We are experiencing a very bizare issue. We have a vlan 169, it has for configip address XXX.XXX.XXX.XXX 255.255.255.224Everything works very well and as soon as we add another IP as a secondary ip for that vlan interface, it starts to time out...

We are running the latest IOS 12.2(33)SXH2 on our L2 6504 and are trying to utilize the broadcast storm control command. When we enable the command on an interface, we get a command rejected response (see below). Can Broadcast control be ran on a 6...

Hi,I am planning to do an IOS update on 3550 switch which is currently under EMI version. Is it possible to put the SMI version IOS on this.

My client is using Novel GroupWise Webmail. We get to the webpage but unable to authenticate. His Novel Authentication Server has a Ip that is static to the inside. The Web access server only has a public IP with an access list that allows any. T...

I am configuring Multichasis LAG between cisco 3750 and Alcatel 7450ESS.Etherchannel is showing up on both sides but no traffic passing through.Also after 15 minutes the interfaces becomes err-disabled on cisco side with message"Channel misconfigured...

Hi,I have attached two text files each of which outlines a different BGP configuration. I have done these two codument to achive a BGP connection to two different providers while we receice Partial routes from them and if one goes down the other one ...

hi everyone,i had this on my routerNeighbor V AS MsgRcvd MsgSent TblVer InQ OutQ Up/Down State/PfxRcd10.254.5.182 4 21302 41005 13798 0 0 0 02:51:07 OpenSenti was unable to ping the nei router10.254.5.182.Is it probl...

Hi,I want to do automation for the port security using TCL . Is it possible to implement of 4849 cisco switches? where do i find relevant material to implement automation on port security?Thankskiran

We have two core switches 4503 C1 & C2. we have configured C1 switch as DHCP server. In case of Core 1 down we need to activate Core 2 to act as the DHCP server. Do let me know how to acheive DHCP failover between the Core switches.

hi every one, suppose i have 3 areas, area 0,1,2. Area 2 is NSSA area. now i can see redistributed routes in area 1 and area 0, i can stop redist routes entering in area 1 by making it stub, but how can i prevent them from showing up in area 0 ? 1) i...

I have a question concerning a high availability design.We are running OSPF internally, all in the same area.My questions are concerning the etherent connections in violet.In our network, internally, all router ethernet interfaces are in the same vla...

Hi,We have Cisco 1841 as the data router. We have assigned 2 secondary gateway ip on this router. This router has default route to the Firewall for internet traffic. Now the problem is only for the users with secondary IP as their gateway. (The secon...