Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Hello, Cisco Community!I’m really happy to share that I’ll be hosting the Cisco Community Lab Series, a brand-new hands-on learning journey designed to help you build practical networking skills step by step.Every Thursday at 8 PM EST, I’ll post a ne...

Hi,I have a WS-C3750G-24T-E that is currently running the following version of IOS which I believe is an EMI image; c3750-i5-mz.121-19.EA1d.Now, I would like to upgrade this to gain some of the additional features, especially around port security, bu...

Hi,Is there anyway implementing stateful NAT on a 6500. I have 2 6500's with multiple HSRP instances but need to deploy destination NAT as well. Any pointers would be great.Cheers

hi every body!I read in cisco book that maximum size for ethernet frame is 1518 byte.My question is why? it should be larger than 1518 because:(assuming mtu=1500)ethernet(dix)header=26 byte.IEEE ethernet(802.3) header= upto 28 bytesIEEE 802.3 with sn...

sarahr202 by Level 5
  • 2905 Views
  • 1 replies
  • 0 Helpful votes

I was recently trying to do some debugs and did not get any output until I turned off CEF with "no ip cef". What are the ramifications of turning off CEF? I assume there are some performance issues but are there any IOS features that require CEF? ...

tato386 by Level 6
  • 865 Views
  • 4 replies
  • 0 Helpful votes

Just installed a 6509e and a 3560 switch in my LAN. Singlemode fiber is connecting the 2 switches using gbics. When moving data between the switches, transfer speeds get no higher than around 50mbps. Doing a sh int gig 5/1 produces the following. ...

vanguard1 by Level 1
  • 937 Views
  • 4 replies
  • 0 Helpful votes

hi every body!i have some questions about DTP.According to cisco, DTP covers encapsulation negotiation( isl or dot1q)and whether the link becomes a trunk at all.Let say we have two swithes: sw1 and sw2sw1 is connected to sw2 by f0/1 and sw2 is connec...

sarahr202 by Level 5
  • 21666 Views
  • 3 replies
  • 5 Helpful votes

Hi There;Has anyone connected an RS-422 interface with a Mil-STD-188/114 interface. Wikipedia (http://en.wikipedia.org/wiki/EIA-422 - 6th paragraph) and the Mil Std website (http://milstd.net/mil-std-188.htm) says that these two interfaces can inter...

austindaz by Level 1
  • 1341 Views
  • 2 replies
  • 0 Helpful votes

I have a Cat3750 using 802.1x Multidomain Authentication (MDA) on the access ports. Which are Avaya Phones authenticating into the voice domain and cascaded PCs authenticating into the data domain on the same access port. So far everything works perf...

is by Level 1
  • 728 Views
  • 3 replies
  • 0 Helpful votes

I have c3508G switches connecting several clusters of 2950T switches. the 3508s are hard set at 1000 meg speed. we are constanting building discard errors and performance stinks. this is happening at several sites throughout our network.

Resolved! ACL help

Im trying to prevent telnet access into my core switch from a guest vlan, and for the most part everything is working well. I have one issue though, and that is that I can telnet to the device from the guest vlan, and I dont want that to happen. Ca...