Switching

"""Hi; After I erased my flash i reboot the Router 2611 and tried to Install new IOS from Xmodem (Console) and when I changed the Baud Rate to 115200 and restarted . Hyper Terminal does not display any thing ...Urgent"""

I am having trouble with a CISCO1811 allowing https traffic. I think it might be an error in my access lists. Any suggestions would be much appreciated.Here is the configuration of the ACL:access-list 1 remark SDM_ACL Category=1access-list 1 permit 1...

I've encountered a really odd issue. Here's the situation:Two routers: 2821 (R1) and 2811(R2). R1 is the main router that carries to-Internet traffic. R2 is a VPN gateway, being also a default gateway for one VLAN (say VLAN111, 10.111.222.0/24). R2 ...

Hi Guys,2 weeks back i have upgraded my IPS4250XL, service pack to "IPS-K9-6.0-4a-E1.pkg" also i have upgraded the signature to "IPS-sig-S328-req-E1.pkg". after doing these upgradation we observe that our mails to outside domain are getting delayed. ...

I was just wondering if there is a cisco way to set up load balancing for a server farm, and base the balance off of cpu utilization on the servers?

Hi all, can anyone tell me when I set up my cisco LWAPP wlc and access points, what vlans do each of the interfaces go in, Ie do I have 1 interface for management of the wlc? and which interface do I connect the access points? do the access points th...

I have the following:DSL Modem into a Cisco Wireless Router w/built in switch that goes to 2 servers (behind NAT) and a cisco catalyst switch connected to the router for all other network connections.The problem is when I goto VPN into the network, i...

hi allAm i right in saying snmp is for basic stats from my switches, whereas rmon uses more deeper mibs, but also uses snmp to transport the info ?

For some reason, one of my customers switches has an awkward vty line configuration that I have not before seen.Here is the config on the switch:line con 0line vty 0 3 transport input noneline vty 4 password xxx transport input sshline vty 5 15 passw...

Hi all when using cisco sona approach, if I was to connect my wan routers to my network, where should they connect? would I connect them into my enterprise edge distribution switches, or would I have the 3 layer model and connect them to access switc...

Hi all, if i have a router with an interface on the 192.168.3.0/24 network and the other on a 10.118.200.0/24 network, but I route other 10.118.0.0 routes out of the 10.118.200.0/24 interface, how do I advertise the routes to that other network out t...

HiI'm not too great with snmp, but is there a way for me to identify which type of snmp counters I'm using on my 3750G switch e.g is it 32-bit or 64-bit?ThanksDan

Guys,This cant be right can it? I want to monitor two ports on a ws-6724-sfp on a 5400 with a sup 720?% This platform allows a maximum of 1 TX monitor interface(s)Can it?Many thxKen6500switch#conf tEnter configuration commands, one per line. End wi...