Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

I am trying to throttle a single port on a Cisco 3560 Cat swith running Cisco IOS Software, C3560 Software (C3560-IPSERVICES-M), Version 12.2(25)SEE2 to 5Mb, can someone provide me with links to where I need to look or possibly some short directions?...

amadeusri by Level 1
  • 2722 Views
  • 4 replies
  • 0 Helpful votes

Hi all,We have OM3 fibers panel (support 10GE) between 1st and 2nd fl. Total 3 connections.We have 4510R with TWO SupV-10GE (Dual Sup) at the 1st FL. and 4506 Sup II Plus 10GE at the 2nd FL.I connect 10GE with trunk without any problem.However, I t...

jolo07310 by Level 5
  • 507 Views
  • 1 replies
  • 0 Helpful votes

Hi all,Im trying to connect fiber cable between 2 3550 switches but it shows me this error:00:32:37: %GBIC-4-CHECK_SUM_FAILED: GBIC EEPROM data check sum failed for GBIC interface Gi0/200:32:37: %GBIC_SECURITY_CRYPT-4-VN_DATA_CRC_ERROR: GBIC in port ...

nomair_83 by Level 3
  • 2715 Views
  • 2 replies
  • 0 Helpful votes

I'm trying to track down the logic for this, any help would be appreciated.For reference, Computer A is attached to Switch A, Computer B is attached to Switch B. Both computers have the same IP address assigned, one obtained through DHCP, the other e...

I have an 1841 router that I enabled the netflow and NBAR on. I can view the protocol traffic from SDM, however, the "Top Talkers" option is not available due to the IOS. What IOS do I need to have this option. Or, how can I find out which ip is usin...

baracus11 by Level 1
  • 584 Views
  • 1 replies
  • 0 Helpful votes

Hi, The following snippet is taken from the following link:http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/122sx/swcg/vacl.pdf"When a flow matches a permit ACL entry,the associated action is taken and the flow is not checked against the ...

Resolved! question about MST

Hi !I'm currently preparing my CCNP certification.I need some clarification about my reading.1- on my reading I had understand if it's possible to avoid to have data trafic in the instance 0 in MST it's better for avoiding problem.2- Is it same kind ...

Hi !I would like to know if I increase the value of the hello timer from default value to 10 sec. What is append on the covergence delay ?I think this delay will increase too but I'm not sure.some one can confirm ?

I veils do not arrive any more to acceder in the interface of the modem for the configurer and the worst it is that I do not even any more succeed in re-initializing reset with the button the Modem.Anyone have a solution for me PLS ? thx for help me....

lyzanders by Level 1
  • 403 Views
  • 1 replies
  • 0 Helpful votes