Switching

Is 80% memory utilization on a 3750 stack (3) abnormal or anything to worry about , I don't believe it is going any higher and the cpu is less than 10% . Not seeing any malloc failures in the log . Version 12.2.35SE2

hello1)in wich cases in RIP WE Need to enable split-horizon2)if we advertize the network in rip via the network command;do we need to configure the neighbor command?many 10xs

hello experts!i entered the command EIGRP Stub under the eigrp AS.but i do not find it when i issue sh run?10xs

Some document says that at the begin, it would show a menu cosists of M. MenuK. Command LineI. IP addressbut mine is no K choice, instead a P for console password configure.any idea?thanks,h

Dear Invisible Mentors,By looking at the following SH VER from my 2621 series, I'm i correct by saying the router has 64MB of DRAM? and 16MB of flash?. Please correct me if wrong and show me how to recognize the amount of DRAM and FLASH in the future...

All, I know this should be in the security forum, but Im not having much luck understanding this at the moment. Can you guys please help me understand one thing in particular:Im trying to find out how to use Dot1x port authentication. What Im tryin...

Hai,Sorry to put very basic quiestion..I always confuse with NAT and PAT ...Can some one help me in understanding the concept and config ...Thanks Lijeh

Consideration of 3750 vs 6500 at the access layer:1) Are the 3750-E failure times slower than a 6500 with dual/SUP'? I'm talking about a master switch failure in a 3750 stack or a stacking cable failure and I need to apply a scenario to an IPT networ...

I am putting this question across since no response fro "getting started with LAN.Dear Invisible Mentors,By looking at the following SH VER from my 2621 series, I'm i correct by saying the router has64MB of DRAM? and 16MB of flash?. Please correct me...

hi all, if i put in an http address such as http://11.11.11.11:5050 what does the 5050 do ? is it using port 80 here or 5050 ?

Hi. Often i find written "a singly link" and i'm not able to figure out what this means. I'm italian so english is not my native language and i get confused if this generally means:- one linkOR- a link that can be used only in one directionSorry for ...

Folks:I woul dliek to create a baseline (standard) for configuring routed physical and virtual interfaces. You know, disabling certain services by default...I have TWO questions, please:1. Does the following dialogue make sense? Am I missing somethin...

I am trying to xmodem an image to flash but when I enter the command in rommon to xmodem. I receive:switch: xmodemUnknown cmd: xmodemNot sure why I am getting this. It has always worked in the past.

I have these strange routes on a Native Sup720 Distribution that I can't figure out where they're coming from. They're all mostly /32's and they appear to be coming from L3 configured port-channels. Here's a couple of snapshots:LOF14DISTRT1#sh ip r...