Switching

We have a WS-C2950-24 switch which is currently in transparent mode . There is two VLANs configured . We want this switch to join the domain . The domain has mode than 80 VLANs configured . I pull my trunk cable out and convert the switch to client ....

Hi, I have this issue to see if someone can help me.I have a big network of 250 computers and I use 4 diferent ADSL connections and I want to put them in a 1 connection but I can't find the way to do it, or at least I don't how to do it. If you hava ...

When I connect a certain network into a port setup for a specific VLAN on my CAt 3750, I cannot access the DHCP scope that I setup on the router for that subnet. I put in an IP Help-address statement, but DHCP is still not working. Should I be doing ...

Hi all, am i right in saying windows rras uses pptp, and cisco asa uses l2tp for vpn, what is the difference here, and would the vpn terminate on the rras server if i did use one ?, lastly does the rras server use ipsec ?

My company is a Fortune 500 company, yet our networking director has always prohibited the use of 100 Mbs to the desktop. From day one. His fear of overloading servers by requests, and his fear of spreading malware "even faster" are the stated reaso...

Which management domain will a new switch join if it added to a network where 2 different VTP domain are present.

I recently came into posession of a Cisco 7200 Series router, which I will be using to upgrade the network of a local non-profit. It came with various cards installed, including a T1 IMA 8-port card (model PA-A3-8T1IMA). Whenever I power on the rou...

I have 2 routers and 2 isp connections. One is a T1 and the other is a 8MBS download Cable circuit. Each connection has a static IP I am connecting to. I have 1 ISA server that all my internet traffic comes through. The 2 routers and the Outbound NI...

I created a VLAN 50 and 51 and gave them an IP address of 10.144.133.1 and 10.144.134.1, respectively. So far, I can ping each interface without any problem, but I am concerned that it could potentially cause a problem somewhere down the line. To giv...

Hi,I am trying to configure DHCP on the E0/1 interface of my router. Is there any way to do this and limit it to only the network connected to that interface? We have set up our router so that e0/1 connects to a test network, seperate from our main...

After setting a switchport to 100 Full Duplex, what IOS command can we use to determine that the laptop client has been set to 100 Full Duplex as well?