Switching

when I use this command on my router, say I am advertising a 10.1.0.0/16 network, will other routers see it as 10.0.0.0/8 ?

Hi allCan anyone tell me how I would configure my firewall in my dmz, would it have 2 network cards one on the lan and external that plugs into the dmz, or would it just have one plugged in to the dmz and we route to this via my default gateway ?than...

can you use addresses with a 255 in them ? on my internet router it has and ip of x.x.255.x !! I thought you can only use up to 254 !!thanks

Hi all, can anyone tell me what I would open on my internal interface for my mail server on my pix ? couldnt I use a router with certain access lists permit statements for port numbers etc ?

guys, i got a 2501 with 8/8 and old IOS. Now i got a latest IOS and a 16 dram, 8 flash. Any1 know how to upgrade my flash. Since my old ios is store in the old flash. What if i remove or add in another 2 8mb flash ? how to load my new IOS into the sy...

I've been given a couple of 3640 routers, one of them had no config and I was able to work with it. The other 3640 had some config on there and heres what I've done so far.*Change config regsiter and booted up to access the startup config. *Copied ...

am I correct in saying the pix 501 has not dmz port ?

I get this error upon bootup of my 3640 router."%SYS-3-IMAGE_TOO_BIG: 'flash:c3640-is-mz.122-34.bin' is too large for available memory (10590520 bytes).bootof "c3640-is-mz.122-34.bin" using boot helper "flash:c3640-is-mz.122-34.bin" failederror retur...

If I configure my switch as a router and put a port in layer 3 mode, will all vlans on the switch be able to see this ?

is this as simple as doing it in eigrp or do you need to create a route map ?

If I have 2 routers, both with connections out the building to the same place, How would I load balance these ? my clients all use the same router for there default gateway !! can someone tell me how to do this using eigrp and also statics ?thanks

Hi allIf I configure 2 vlans on my switch with ip say 172.30.1.x/24 and 172.30.2.x /24 will this cause any kind of overlap error ?

I have one pc in my office and one in my home. Office pc is running Windows XP and my home pc is on windows 98. Now i want to Access my office computer through my home computer. I have also installed (Remote Desktop Connection)(An XP facility) in Win...

Does spanning tree primarily use the bandwidth to achieve its goals, will spanning tree block the slowest link back to the root bridge ? and also what is a designated switch ?

Can anyone tell me how I can get my router to give out ip addresses to a particular vlan only and nothing else on my network ?