This morning, I found that the C9115 AP led light connected to the C9300L-24P-4X switch blinks red-green-blue cyclically, and I checked the POE switch and found that the poe status of the port connected to the AP is down, but I can see that the inter...
Forum Posts
Recently need to upgrade C9407 Current version: 16.12.03aTarget version: 17.9.6a Supervisor 1 XL Module with 25G FW: 16.12.2rCPLD: 19032905 Two 9407 SVL units---Can't find the upgrade path in official documentation?Can we upgrade directly from 16.12...
Also sorry, english isn't my native language so I tried to translate the assignment as best as I could.I only managed to do the DHCP server & I am not sure if I did it correctly or not. Because I tried other things like doing the ethernet channel but...
Hi guys .The SOC administrator in my department told me that, for the purpose of securing the network, I should disable the password recovery service so that no one can access the switch configurations just by having a console cable. But I’m not sure...
Hello all,Can anyone explain why RSTP does not have forward delay timers, and what are the port transitioning states.
I'm a new user of Cisco products in a public transportation agency and I'm working with both the Cisco 819 and 829 routers. These devices are installed on a large fleet of vehicles.We have written procedures for setting up both models, but the engine...
I checked the following document and found that “ACLs cannot be configured on management ports.” but we confirmed that it is possible to configure it on the actual device at Is this an error?interface GigabitEthernet0/0 ip access-group 111 in ip acce...
Resolved! access the web on a WS-3650
Good morning team, how can I access the web on a WS-3650? I've already created users via SSH and it opens properly, but I can't log in via the web.Could you help me?Thank you.
Hi Team,Users in my network are receiving bad IP addresses, and our DHCP scope is set up on a Microsoft Windows Server.Please assist me in resolving this issue and let me know if you need any information from my side.
Hi Cisco timI would like to ask about the compatibility matrix of the Cisco Nexus C93180YC-FX3 with the SFP-10G-T-X transceiver. I plan to use 32 or more units of the SFP-10G-T-X transceiver on a single Cisco Nexus C93180YC-FX3 device.My question is:...
Hi,May I ask if there is any way to deploy my own class-map into the default system-cpp-policy?I’m trying to restrict SSH connections to only one loopback address, and have all other IPs dropped.On basic routers, I achieved this using an extended ACL...
Good Day All, I currently have a C9300-24P-E , brand new out the box. I see that we are going to need AVB support which is only supported under DNA-Advantage licensing............ I tried to run the "license boot level network-advantage" command to t...
Resolved! Switch no guarda configuracion WS-3650
Good morning, team. I have an issue with a WS-3650 version 16.12.13. It's configured correctly, but when I unplug it and plug it back in, it appears to be back to factory settings.I've already tried doing this to configure the registers. config-reg...
I am trying to get a better understanding of why something is working. SW1 is another vendors switch which connects there devices, SW2 is my switch which connects devices on my network. SW1 and SW2 are connected via a trunk link that allows VLAN 30...
Greetings,I have aquired a second hand WS-C3650-8X24UQ-S. Appears to be working as is (connected to router and one pc), and no password. When looking up reset instructions, I see typically you flash_init, then delete config.text and vlan.dat (after h...
