TelePresence and Video Infrastructure

hai allmy connection is like EPBX ------ R1 ______________ R2 ------EPBXConnectionepbx ro R1/R2(2811) is an t1/e1R1 to R2  a leased lineProblem: when we are trying to call from phone connected @ PBX A to PBX B get ring , when we picks the phone the c...

I need to look into how a Cisco router would be configured to act as a H323 proxy for Video conferencing.I have looked for configuration examples but cannot seem to find any.I am looking to have an outside company come through a VPN tunnel we have wi...

I am configuring CTS Manager & Multipoint to interface with CA Spectrum management software through SNMP v2, the administrator of the CA Spectrun Software is asking for the MIBs & OID. From where I can get the MIBs & OIDs and which MIBs & OIDs I shou...

Guys,ive used the search button numerous times for this but id still like a definite answer. Can MPE be integrated with CCME for Video? im seeing all pointers saying no and some older documents that actually state this but i was hoping that the newes...

I    logged into Cisco.com/go/license and downloading the CUE Port license using    the series of attached serial numbers. The installation on the CUE failed,    with an error message "that the specified uid in the license file was not    found". I s...

Is any solution guide or write-up available to enable more than one congruent interop session between CTMS & CUVC? Do we need to configure more than one SIP trunk between CUVC & CTMS.Please suggest steps or forward write-up.Thanks.

For G2 routers such as 2900 or 3900, what video features does it offer?

Hi,I am just wondering if i could upgrade the IOS on a CTS1000 without Call Manager? Is it possible to just use a TFTP server and upload the new IOS onto the codec with no CM?Thanks

Hello,I am trying to change the ip address to a cucm 6.0(1) using the console port (set network ip eth0  "addr a.b.c.d"  "mask a.a.a.b") every things look O.K. but after the cucm restart the new ip address never appear and still i can see the old ip ...

I am interested in information on how to integrate to Cisco Telepresence so that audio and video could be displayed inside of another application.  Any information on APIs, frameworks or client software that would enable this would be helpful.  I am ...

Greetings!My CTS 1300 1.5 codec is due for an upgrade to 1.6.I've downloaded SIPTS.1-6-0-3945R-K9.sbn from CCO and uploaded to CUCM tftp.The codec complains about not being able to find the file. I have checked the CUCM tftp, and it is there OK. I've...

HI,I have installed ICM Rogger (Router+Logger) on one MCS Server and AW& HDS on Saparate MCS Server.All the services of Routers & Loggers are working fine, but the moment I installed AW & HDS , then Logger service is unable to start(Unable to start ...

I am trying to register my MGCP gateway for use with 10 PRI E1 channelsBut debug mgcp error dives the following000132: *Dec  3 16:47:03.551 GMT: //-1/xxxxxxxxxxxx/MGCP/mgcp_mp_get_not_entity(830):[lvl=2]Invalid parameter (pkt 0x67A43378 pkt->mgcp_par...