Hello I have some questions regarding PresenterTrack on Room EQ with PTZ 4k. 1.In a lecture room, a teacher is standing front 2 monitors that is sitting on the wall side by side.One monitor with the presentation and one monitor with the online partic...
Forum Posts
I migrated a TMS server in the lab months ago and I'm finally getting around to looking at these errors. Essentially, TMS is generating tickets saying that the services aren't running. The services are running, but TMS is looking at the old FQDN, whi...
Roomkit EQにDSPとしてP300（USB接続）の利用を考えておりますが、Cisco Table Microphone Proとの同時利用は可能でしょうか。 同時利用が可能か、排他制になるか教えてください。
Hi Dear friends,I have Cisco Meeting Server (CMS) 3.9 and Cisco Meeting Management (CMM) 3.9. When I create an ad-hoc conference from an IP phone, the calling number is correctly displayed as the Directory Number (DN), and everything works fine.Howev...
Hello Everyone I got two new Cisco 9951 phones. I have registered them on cucm12.5. The phones can make calls but video is not transmitting. Audio is working very well. Other phones such Cisco 8945 and WebEx are working for both audio and videoOn the...
Resolved! Cisco room kit : disable SIP
Hi, I need to use H323 protocol with my Cisco room kitIt says I can't use both protocol at the same time SIP and H323. So I have tried to disable SIP, but I could not find, on the web interface how to disable SIPWhere and how I can disable SIP defini...
Hi,can you tell me if Cisco Room Kit Plus is compatible with Microsoft Teams? Thanks
Hi Everybody, Connection pathRoomKit Plus --- CUCM --- ExpC--- ExpE --- (internet) --- WebexThe audio call from Roomkit to webex is fine.However, the video does not come up on both endpoint.I have checked the SIP INVITE signal,CUCM received the (INVI...
Resolved! Similar authentication -CUCM
Dear All,Can we configure similar authenthication username and password in different Extension number in CIsco Call Manager.Thank you for yor replies.
Hi I have a dx70 that currently has developer version installed. This is not allowing me to upgrade. I follow the steps below and nothing works: 1. follow steps on the conversion guide from android to ce 2. factory reset 3. pointed dx to cisco upgr...
We have a SX10 camera, touch 10 control panel and a 65in tv. is there instruction on how to set it up for using Webex and Microsoft Teams.
I can't set up 802.1x from Touch 10 on cisco sx80
This installation has a Webex Room Kit EQ running as a Microsoft Teams Room (MTR)The Room Kit EQ is connected via USB A to a QSC NV-31-H for audio.I have audio in and out of the codec. i am able to adjust the system volume on the 'cisco' side of the...
Hello, I am having an issue with configuring my Webex. I log into the unit through a network fine at my test bench. I then proceed to change the configuration in the Settings tab. I save every change I make just in case I time out. Once I have made a...
Hi, all.Greetings. I have two Cisco room kit EQ with Quad camera then found difference when setting 'zone' setting.One has zoon as below.The other one shows four blue corners. The issue is ; with those four blue, camera simply doesn't show when in au...
