Unified Computing System Discussions

TAC has turned a customer around and pointed at a compatibility matrix for an installed UCS-C 260M2 claiming that the firmware on the UCS and the current version of Vmware is not supported. They are suggesting that the customer moves to fimware 1.5(9...

Hello Team, i have a confusion and wanted that to be clarified. Is it possible to remove memory modules from Full blade (B 420 M3) and add them on half blade (B200 m3)? RAM on full width server is 16GB DDR3-1600-MHz RDIMM/PC3-12800/dual rank/1.35V.  ...

In our UCS environment, both fabric interconnects has Cisco Nexus 9k as upstream switches with vPC and it is running fine. But we need to isolate some virtual servers on UCS blades on a entirely separate DMZ switch which is Cisco catalyst 2960. 1) So...

Is there a maximum number of vNICs allowed per blade/server profile when using 6248 FIs and B200 M4 blades with 1340 expander cards and is the number of vNICs allowed lower with the same blade but with no port expander card?

I'm looking for a way to show the listening ports on the UCS FI. I could do a port scan externally but I cant automate that with Tripwire.  I want Tripwire to SSH into UCS and execute a command to tell me what ports are listening? Is there such a co...

For every Out-of-band IP assigned, The switch is having ARP overwrite issues.  The MAC addresses for the out-of-band ips switch between the MAC of the management port of FI-A and the MAC of the management port of FI-B. These FIs are being hosted of a...

Hi Team, There are few degradabale memory errors. As per the documents it says it need to do scope cimc and then reset. Though I see in the document just wanted to make sure the doine scope cimc and then reset for the server is not disruptive or do ...