Unified Computing System Discussions

Having a buch of UCS C240 M5 servers, updated recently to the latest firmwre. I am trying to boot the server from a disk image (.img) This image consists of Alpine Linux 3.15 and based on ext4 file system, initialised by Syslinux.Both the server and ...

 I can't download UCS PE on any version with any link.  I've created userid's for cisco and devnet and any time I've connected to a new website, same thing.  Any suggestions?

I've been reading the Capacity Management in Cisco HyperFlex White Paper, and I have a couple of issues with the wording used in this paperIn particular, the use of the term "persistent tier" - in fact, I believe the term "persistent tier" should NOT...

Hello.As you see a title, I want to know whether I can shut down CIMC with ISE application running and how this operation affects ISE application.ISE is running on UCS Server.Here is the information about UCS Server and ISE version.------------------...

I am new to Hyperflex and trying to build a 3-Node Edge Cluster with HX 220c M5 servers. - Nexus 9k in place of Fiber Connects- Jumbo Frames are enabled- There are 4 VLANs created on switch as recommended, with coordinating IP structure- ESXi 6.7 U3 ...

Hopefully this is a simple question, but the C220M5 we ordered has its management port and 2 x 1/10gbe ports. i would ideally like to use these 2 x 10gbe ports for connecting to storage, but if i do so can i use the management port for both cimc and ...

Dear guys, I am having a trouble with Cisco UCS C220 M5. When I  boot to CIMC, there is an error as picture "M.2 SWRAID configuration is not detected". I tried "Load Manufacturing default" but it did not work. Please help me. Thanks a lot

I have one IO module 2208XP connected to chassis 5108. It is connected to a FI 6400 series with 4.2(1i) firmware. When it was connected, the IO module is showing Identifying, and then Auto Upgrade, after that the IO module is rebooted. When it was up...

Good afternoon.   We have UCS Mini. Connected the following way: cisco switch-- > UCS Mini-- > ESXi. It turned out that on one blade we need to install ESXi with several VLANs on one interface and drive it into the ESXi sweep. We have set up a servic...

Hi, I have a UCS domain (2.2(8e)) that I need to decommission, but I'm struggling to find the correct process or steps required on the UCS side of things to do this. Does anyone have a guide, or can point me in the right direction for this? Thank you...

Hi All,  i was exporting the config files and it is stuck for almost a day now how can I break/stop the process thanks in advance   

Hi Guys, We use UCSB-B200-M3 and one of the server is faulty. We replace it with the same type (refurbished).  We insert in slot 6 and it is discovered in UCS Manager. But in Adapters menu, HBAs and NICs is not detected. While in DCE Interfaces, from...