[Relocating this post from another thread]
"I'm seeing an issue with just the base "out of box" (8 ports per FI) licensing. It shows that there is a 120 grace period and it's used 3 of them.
Here is the error:
warning F067093835 sys/license/feature-ETH_PORT_ACTIVATION_PKG-cisco-1.0/inst-A/fault-F0670 license-graceperiod-entered license for ETH_PORT_ACTIVATION_PKG on fabric-interconnect A has entered into the grace period.
warning F067093836 sys/license/feature-ETH_PORT_ACTIVATION_PKG-cisco-1.0/inst-B/fault-F0670 license-graceperiod-entered license for ETH_PORT_ACTIVATION_PKG on fabric-interconnect B has entered into the grace period."
Note the following changes in regards to licensing:
- Prior to 1.4 the first 8 ports were "licensed" by default (16 ports for the 6140). From 1.4 and later you can use any 8/16 ports.
- Each port maintains its own 120 day grace period.
- Port licenses are bound to the Fabric Interconnect Serial #
- Licenses are NOT applied to a port until it's Enabled
- Expansion modules ports are NOT licensed from the port pool. They are fully enabled at manufacturing (their own built-in license)
- You must install licenses "symetrically" (Each FI with the same # of licenses) to avoid inconsistencies during a failover.
If you're having issues with licenses check/provide the following output:
scope license
show usage detail
show file detail
scope eth-server
show interface
scope eth-uplink
show interface
Regards,
Robert
