About ahmad_tamneh

ahmad_tamneh · 04-06-2013

The Gateway in the other cluster is MGCP , and all the PRI are backholded to the ccm The requirement...

ahmad_tamneh · 03-27-2013

Hello All... I have the following setup, I am not sure if the will be suitable to enable the MVA fea...

ahmad_tamneh · 09-18-2012

I saw it already,How about terminal.

ahmad_tamneh · 09-18-2012

When we talked about the type of the gateway (as endpoint) that can register with cisco gatekeeper, ...

ahmad_tamneh · 03-12-2012

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a008009428e.shtmlCaller ...

ahmad_tamneh · 03-12-2012

Dears,I have MGCP gateway, it has Vic2-4FXO , one FXO ports has analog line that is connected to Tel...

ahmad_tamneh · 06-26-2011

Hi Amer, Let me check to answe you.Ahmad

ahmad_tamneh · 06-26-2011

Hi all,I have MGCP GW, registered with CUCM 8.5, the gatway has 3 fxo they are grouped with one Rout...

ahmad_tamneh · 05-24-2011

Hi all,I have this case, I have 2 systems, one with CCM 5.1.3g,which will be migrated to new system ...

ahmad_tamneh · 04-26-2011

Hi,you may also use CFW ALL Calling search space with no access to any partition

ahmad_tamneh · 04-22-2011

Hi Ali,Well, as beginning you have to try using the cptone SA under the voice port , some times it w...

ahmad_tamneh · 04-21-2011

There is a frequency used with the FXO port to allow it detect the Disconnect signal,you need to fin...

ahmad_tamneh · 04-17-2011

Hi clileikis,Yes I can say it happened most of the time, we did not reboot the call manger recently

ahmad_tamneh · 04-17-2011

Hi Paolo,mm you can say that in the bad cases it may take more than minute ..now specific ?

ahmad_tamneh · 04-17-2011

Well, Amer you are right, I checked earlier the speed between the switch and the CUCM, but the stran...

Date Registered	‎08-05-2008 06:55 AM
Date Last Visited	‎10-18-2020 11:35 AM
Total Messages Posted	81
Total Helpful Votes Received	45

MVA Feature Functionality