Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,On a Cisco IOS router, when the sccp command is configured, the following message is sent to the console port:SCCP operational state bring up is successfulHowever, this message is not sent to telnet or ssh sessions via VTYs, or to AUX portsIs this...
Hi,I am looking for a way to put a customized text mesage that can always appear in CM Administration window for CUCM versions 8.5 and 8.6 (not just when logging in, but also while configuring IP phones, Route Patterns, Partitions, etc). Maybe...
Hi,One customer has requested to set up a call handler in Unity Connection 8.5. The call handler should be capable of transfering calls to IP phones by dialing the last 4 digits of the IP phone's extension. The last 4 digits of the extension from all...
Hi,Does anybody know if the WAP4410N access point for Small Businesses support any Discovery Protocol like Cisco Discovery Protocol (CDP) or Link-Layer Discovery Protocol (LLDP), both for sending and receiving frames? I did an extensive search on the...
Hi,We have a standalone Service Monitor server, that resides on a separate server from Operations Manager, we have not a multi-server environment, and the communication between the servers is not enabled by a "trust" model addressed by certificates a...
We also got this error message after migrating AAA for Cisco IOS, HPE ProVision-based, and HPE Comware-based devices, from CiscoSecure ACS to HPE iMC TACACS Authentication Manager (TAM), by only changing the IP address on the tacacs-server host comma...
Hi,I know that this is an old post and that the solution for CallManager 6.1 is to use BAT export ALL DETAILS option, delete phones, modify DNs in BAT, reimport using also ALL details. However, I would like to confirm if for CallManager 8.6 this is t...
I had the same problem with a 2811 router in ROMMON mode and an IOS image of 58 MB of size in a Flash memory of 64 MB. I tried with several TFTP server software (tftpd32 among others), but it always get stuck and timed out at around 60% of the TFTP t...
I am experiencing the same problem, and have tried the following options:Disabled all HIPS in my local machine and ran the installation with administrator privilegesTried to install anyconnect-win-3.0.5080-web-deploy-k9.exe from the ASATried to insta...
Hi Manish,Thanks a lot for your suggestion. However, I followed it in a CUCM version 8.0.3.20000-2, but I did not have the Require User Acknowledgment checkbox, as you can see in this screen shot:Also, I would like this text message to always appear ...
