Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a lot of users that can't follow directions so we want to completely disable the feature that allows Webex to call participants. Is there a way to do that and if so where do I find it in the Control Hub? Thanks in advance!
There was a post about Chromebooks and Jabber from 2019 but with newer versions of Jabber out there is there an updated list of what Chromebooks, if any are compatible with it? With COVID and working from home we're becoming dependent on Jabber for ...
I'm setting up a lot of small remote sites that are only reachable via VHF ethernet radios that operate at 32k. I'm going to be using 2 of these radios shooting to two seperate base station radios to provide diversity. I'm going to have a Cisco 194...
Here's my problem. I'm going to be using Cisco 1941 routers at a bunch of remote sites. All of these sites have 2 comm paths out. Some of them have 2 IP/VHF radios and some have 1 IP/VHF radio and a copper link using Patton ethernet extenders. Fr...
So our IT guys installed LMS 4.0.1 on a VMWare machine. I went in and added a seed device, set up the credentials and other discovery settings. Ran a discovery and came back the first time only discovering around 125 devices of those only 4 of them...
Thanks for the reply. I feel stupid that I didn't check that first so after reading your reply I did. I see nothing in the 12.9 or 12.8 notes referring to Chromebooks. I'm sure I could be looking at the wrong thing. If you have a link would you m...
Ok I found part of our problem with this issue. The radio interface was being sent to a layer 2 switchport. I switched it to a layer 3 instead and that fixed it. I changed the OSPF priorities and tested it and it failed over as it should have and ...
Rick,Thanks for the reply. We have tried this with the cost and it doesn't seem like it's working either. Do you need to change the cost on both ends of the link? Do static routes affect this? Somewhere along the line a previous network engineer ...
Have there been any other fixes or workarounds for this issue? I'm having the same exact problem on my client machine and have tried pretty much everything on this page. We're using LMS 4.0.1. We just installed it and I've been having loads of tro...
Oh, I have one more stupid question. When I have the topology map open and I try to run a report of just about anything else it attempts to open Firefox instead of IE. I have IE set as my default browser but FF still keeps opening. Where in Cisco...
