Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 3504 that I have been able to update as far as 8.8.120. Multiple attempts to update to 8.8.125 have failed. I have tried via GUI and command line. Consistently fails trying to expand the file downloaded from CCO. Anyone else having this...
Is there any way to take the configuration from a WLC2504 and move it to a 3650?
My current LAN/ WLAN is based upon a 3750X switch and a WLC 2504 with (3) 3802i APs. I am hoping to consolidate the switch and WLC functionality without having to recre...
I am experiencing this BUG on a 2504 controller with (3) 3802 access points. Anyone know if an update to the 2500 series controller has been published or available?
HelloI have upgraded all of my endpoints to CE 8.3. I am noticing diag failures detailing the lack of NTP entries. If I do enter servers they are lost upon reboot or power failure. Each of my devices is registered to CUCM version 11.5.1. Is ther...
HelloI have been asked if it is possible to limit Jabber registrations to devices provided by the employer. If such is possible, I would appreciate any direction given.
Have you tried changing the LACP rate? Sometimes the default of "slow". Is just that, too slow. https://www.cisco.com/c/m/en_us/techdoc/dc/reference/cli/n5k/commands/lacp-rate-fast.html
I have used the mount described in the link below under tables. Please note I did mount the Cisco provided mounting ears with the tabs towards the middle of the switch to create a better balance. I also set recessed the under desk mount to keep the...
Well the licensing appears to be the issue. I removed the RTU licenses and the unit updated to 8.8.125. I did notice that my RTU count of (5) put me at (6) including the one license that comes with the unit. I have since reassigned to a total of (...
I am starting to think there may be a licensing issue. I am using RTU license. I added (5) license to match what I had on the 2504 controller I am replacing.
