Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I have a 3810 Router and I am finding the way to use netflow in it, but the command ip route-cache flow do not exist in this IOS version, ¿could anyone say me if I need use other command to obtain the report of flow traffic?
Hi, please anyone could explain me how should be a conecction over internet to offer a service with QoS in VOIP? My escenary is a 2811 Router with a T1 connection, also have a branch with ADSL i do´nt have the ADSL Router still. ¿Is factible work wi...
Hi, I need install a equipment which work with VOIP configuration to support a propietary system but i should use this system to offer in the future other services in the company, what are the Cisco Systems solutíon that a should use ?ThanksFabian
Hi, i´m installing a router 3810 with to serials interfaces which are using a point to point frame relay circuits each one, my routing protocol is RIP and i will change to Eigrp 10, anyone know how can control that only the HTTP traficc acrooss to t...
Finally i had to change the Ios version to mc3810-i-mz.122-12l.bin and all the Netflow v5 commands works very well, but when the router start with this IOS all the frame relay point to point connectios are in state down, ¿do you know if this behavio...
Hi Friend The IOS Version is 11.3(1)MA7, and when i type ? after the command "ip route-chache flow" i have only these options (see bellow) hq2(config-subif)#ip route-cache ? same-interface Enable fast-switching on the same interface
Ok, so the router will use the other link to send web traffic be cause it permit outgoing traffic? do you know how show o see the comsumit in each link?fabian
I understand your point, so what is the behavior if i will use "for example in your configuraction" the serial 1/0 interface to VOIP channel of 64 kbps too, ¿the router will use the s2 interface to send the data with preference ?, I can program the...
Ok, Adam Today I have a router working with two private services, in the S0 I have Frame Relay (Voice (60K and Data 60K) in the S1 i have a Frame Realy (Only Data 128 K), I am not sure if the router is manage the traffic and which interface is use t...
