Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone,
I'm having issues with obtaining DHCP from a different subnet. Did some troubleshooting, but got to the point where I had to reach out for support.
I'm trying to obtain a DHCP IP for the client directly connected to the Branch Office C...
vEdge not listed under WAN Edge in Vmanage. When checked the running-config from vManage > Configuration > Devices following error is shown. It was shown previously. Device data error[vmanagedb] No system ip found for uuid (Chassis Number) Can ssh t...
Hi Good day! I'm having an issue in one of my 10 APs (1832I) where it doesn't join the Mobility Express Controller. It was working fine, and the cause of failure is sudden. I have attached the console output from the boot-up process. It keeps restart...
Hello! I just reserved a DevNet lab. However when I try to connect to the lab through AnyConnect the session gets timed out and gives me a message asking to check my internet connection, which I have checked and working perfectly. Lab Network Addres...
Hi @Harold Ritter
Thank you so much. This is well understood.
I will follow the above steps.
Also, any references/configuration guides to solidify the statement "Do not configure vlan10 on the head office side" I would greatly appreciate if you cou...
Made some changes. Pls refer below.
I have configured 'interface vlan 10' in both branch office and head office. Pls refer below. Will the branch office send the DISCOVER Packet out of it's exit interface? and reach the Head Office core switch where...
Hi Harold, Good day.
Thank you ever so much for the response. This is well Noted.
However, I made some changes, would this work? I want to have the DHCP Pool for the Branch Office (vlan 10) configured in the Head Office Core Switch, rather than havi...
Hi thank you for the reply. Noted. The things here, is that I have clients in the Head Office configured under vlan30 to receive DHCP IPs, (locally) from the DHCP pool vlan30. I want to extend that same DHCP pool for the Branch Office users in vlan10...
