Voice Systems and Accessories - Small Business

I recently purchased the subject phone and noticed that the transmit (Tx) audio is garbled but only when someone calls me.  The phone is updated to the latest FW.  I always run the G711u law codec.  I can immediately swap this phone out with my older...

Polycom Soundpoint IP 330 phone will not register with Asterisk server through SPA122. Problem seems to be that the port the Polycom is coming into the server on is being changed from 5060 to another port by the SPA122. In this case 58920. Addr->IP  ...

I am getting the following error when trying to do a factory reset on the unity express module.  This is a brand new box.  First time I am going to set this up.  Any help woudl be appreciated...UC560#service-module integrated-Service-Engine 0/0 statu...

Hello! Could you help me please? I can't understand how does it work. I want to modify CallerID of inbound calls incoming from SIP line. I found this strings in locales: <IncomingDialPlanManipulations>   <sip><:_sd_>0[1-9]x. | <:_sd_0011>[1234578...

Hello With respect to BE6000 ordering guide at http://www.cisco.com/c/dam/en/us/products/collateral/unified-communications/business-edition-6000/guide-c07-717328.pdfI need BE600M system so selected BE6M-M4-K9 product codeLicense to be added through R...

I have the program samples to update a CISCO SPA5xx phone via HTTP URI.  Unfortunately that URI is not accessible via NAT.I would like to be able to update the display from the Dial Plan (ie as the call routing progresses).  We use FreeSwitch, but re...

1. 192.168.15.1 does not appear to work.2. My unit Serial # is CCQ17081ALW Please assist. ThanksIhor

I've replaced my older SPA-942 with the SPA-525G.  .  My question is about the soft-keys that appear when you're connected to a call.  I proceeded to alter the programming on that line in the GUI for "Connected Key List" and now I can't get the "Conf...

Hello All, Despite the fact that the SPA5XX work in SIP/ SCPC, I would like to confirm if sidecar works with CUCM 10.X/11.X while configured on SIP. Thanks

I have both lines on my spa112 stuck with call that are in progress and no matter what i do i can't disconnect the calls.I reboot the ataI factory resetis there a way i can ssh to the box and kill the calls?Thanks

It would be nice, if someone could tell me, how to add a e.g. 9951 ip phone to a UC 520 with Version 15.1(4)M6, RELEASE SOFTWARE (fc2) running.is this possible at all? and if so, how?thanks for all and cheers,Roman

Hi All, I am trying to alter the call waiting tone on a 504 but regardless of what change I make I seem to get the default Call Waiting tone when on a call. I have changed the Call Waiting Tone to 440@-10;*(.3/55/1) from the default but doesnt appear...

I have two SPA525G2's in my office.  One is at my desk and connected directly to my WIFI router using the LAN port, the other is at another desk using WIFI only.  The WIFI unit indicates it has a full signal, its probably 5 foot away from the wireles...