Hi All,i am facing strange problem, only one time caller id appears and next time it always shows UNKNOWN Number ??I try with a normal phone and the telco is sending the caller information.i am using UC540: "flash:uc500-advipservicesk9-mz.151-4.M5"...
Why are there no wall mounting slots on the bottom of the SPA3102?
I have a customer with a UC320W with latest firmware. We are having the issue in which incoming calls, which are originally routed to a hunt group, are avoiding the ammount of seconds it must ring before going to our AA. The only way to resolve this ...
Is there a user guide for FXS phones?I'm having a hard time finding FXS feature codes for invoking features such as transfer, callforward and DND.ThanksChris
We need to migrate from a CUCM 4.1 to a UC560.If memory servers, CUCM is the older Windows based version of CUCM.Are there any tools of methods I can use to pull a readable config dump from a CUCM 4.1 to serve as basis for the config of the UC500?I'm...
I am learning VoIP and am going to set one up at my house for experience training but need some advice since I am getting some conflicting information.I read that all you need for a basic VoIP setup, (not Unified,) is an IP Phone like the one I purch...
Dear all,I have a question concerning Cisco BE6000 licensing. I'ts clear that MD server support 1000 users and 1200 devices.In this case, Can I add additional phones from UPM or CUCM without being associated to a user ? Means,that I can have 200 addi...
We have a customer that uses the forward message option in CUE quite a bit. They want to have the system use extensions for the addressing by default instead of having to spell names. They are already aware of the ## option to switch to extension add...
Hello,I have a customers which have two Cisco UC560/540.The both site are link with VPN IPSec (not with Cisco UC).They can see together with private IP.The Voice subnet are the same (10.1.1.0).How can I do for link both system and than user can dial ...
HI All, I am new here so ragards to ALL.I have switched on my new purchased SP122 ATA voip modem\router have connected it to my main adsl router, the lan connection is ok, the adsl routersees the ata mac address\ip, but when I call its ip in the brow...
In SPA3102 data sheet there is a line:Data networking • IPv4 (RFC 791) upgradeable to v6 (RFC 1883)When we will have ability to point IPv6 host as PROXY?
When I originally setup the UC540 with the SPA525G2 phones, the inbound calls were handled via the FXO ports, outbound calls when via the SIP trunk. After things were relatively debugged, I ported the telephone numbers to the SIP trunker (Broadvox, ...
Good day again,still problemsI have SPA122 connected to dual WAN balance router. SPA is working perfect and no any problems with calls but...When I lose one Internet source (primary) and balancer switches to another source (secondary) modem cannot ...
Hello,Is there any plan to implement DHCP Option 60(vendor class id) in SPA100 series devices in future FWs? CISCO SPA5xx series already has this option implemented. Regards,Josep.
Hi is it possible to cluster BE 6000 9.x Callmanager application (UCS 220 M3 server) with a MCS 7825I5 server as a subscriber?Thank you.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: