Voice Systems and Accessories - Small Business

Hello, I have downloaded all files for make update and read manual but when I send uc500-advipservicesk9-mz.. after 35% I have error and it's writed: Fatal Error please contact cisco...and same for CME I have error after 5%.I have by port console for...

CCA software are writed in JAVA ?

What is the easiest and/or best way to disable telnet and SSH access to the WAN port on the UC500?

I read the CCA 2.0 OOB and didnt see where the OOB extension numbers were listed or any suggestions of what numbers to use for the AA that would not conflict with anything else. Can anyone point me in the right direction?

I am looking for some ideas for a pre install questionnaire.  It would include information about network, call handling, auto attendant, users etc.  Basically, everything you would need to configure the system before you go onsite.  If someone had so...

We are setting up a VPN using the router inbuilt in the UC500 and wondered which VPN client the remote user will need to use?

Hi,i have some problemx with a fax, incoming fax in error, i get just some part of the fax and i had an error.I have configured them with CCA 2.0 analog port fxs 0/0 is in mode "FAX" signal "loop start" extension "301"Some fax are good and other are ...

Not sure if this is the right forum so please forgive me, but it does pertain to VoIP, I promise.So, I initially purchased the SPA3102 and loved it so much because it allowed me to connect a POTS line to it and have incoming faxes flow through the 31...

Hi,I have Sipura SPA 2100 Serial No 88013SW00759. I tried calling support but they can't recognize serial no.I get network connection as disconnected. I tried to check IP using IVR menu and don't get any prompt. I think firmwareon this unit is corrup...

Hello All!I use CM 6.1.I try connect PAP2T-EU to CM...I have not expirience work with Linksys so I can not configure Linksys corret...Can anybodu provide step by step configuration?Thank you very much!!!

Customer has the following setup:DSLmodem<><><><><>NETGEAR Router<><><><>PAP2<><><><>Two Analogue Phones.Customer has subscriber information correct.Has latest version 3.1.23Cannot hear anything when making internal calls, no audio on both only dial ...