VPN

HiI have a 5505 connected to 5510 via a site to site VPN, the vpn has 5 subnets on the acl list at both ends, but 2 of the subnets are assigned for remote access on the main 5510, which means the flow of traffic on these 2 subnets are main to remote,...

I have set up a VPN tunnel using pre-shared keys between my ASA5505 and a Checkpoint firewall (another company).I can initiate the tunnel from my side, but they cannot open it from their side. We get Phase2 failures.The other company is saying:"Your ...

Hi all,recently i am tryinng to configure get VPn on my routers, where all the sites are connected over MPLS and cisco 3845 router on the HO as Key server and for testing one GM 2811 on the remote site. After configuring it my tunnel is estabslished ...

Scenario: ASA 5520 with 8.2 firmware, AnyConnect SSL VPN Client 2.5.3046 on Windows platforms, and Windows 2008 R2 NPS server RADIUS.  I've read a lot of blog posts regarding various aspects of this scenario, but none fully describe how to setup the ...

i have an ASA 5520 ver 8.4 with the following configWAN207.211.25.34Production10.11.12.1 255.255.255.0Mgmt10.11.11.1 255.255.255.0i need to create a peer-2-peer VPN to a remote site ASP16 from both Prod and Mgmtwhat would my nat statement look like ?...

Hi all,We have a customer with a DMVPN network. On some locations we have some issue where the IPsec/GRE tunnel to the headend is hanging from time to time (every two/trhree days) and no traffic can be pass through anymore. The solution is to restart...

Helloit seems when a client disconnects from easy vpn server the isakmp session won't terminate at all. As i wrote on a previous post i have problem when a clients disconnects aggressively from easy vpn server ios router: ip local pool won't refresh ...

Hi,I need to change the peer address of one of our site to site VPN tunnels on our Cisco ASA. My colleague seems to think I need to delete the entire VPN and start from scratch. Ideally I would like to change the peer address through the ASDM gui if ...

Hello everybody,I have a Cisco ASA 5510 and a Cisco ASA 5505. I want to configure the ASA 5510 as Easy VPN Server and 5505 as Easy VPN hardware client.Can somebody point me to the right technical documentation on how to do this? Using either CLI or A...

Hello everyone,I have a Cisco ASA 5510 and I want to configure as a Cisco Easy VPN server. Can somebody point me to where I can find a technical documentation or actual configuration on how to do this using either CLI or ASDM? Thanks a lot in advance...

Hi All,Can someone please advise if the existing anyconnect SSL session will be terminated if I put new SSL certificate on ASA's outside interface at the same time?Thanks

Helloi have cisco 5505 and i confirgured a remote VPN clients.  here is my scenirocisco switch 2950   ===  holds two private network 192.168.8.x  and 192.168.4.xvlan 2  outside interface -    Eth0/0       155.155.155.xVlan 1 inside interface --      ...

Hii have a Ipsec tunnel between a ASA 5510 (Uk) & a router (France) that seems to be going down a specific times during the day. I have attached the sys log as well.I cannot seem to copy & paste the config onto here for some reason so i have attched ...