VPN

Hi, I need to disable NAT on a Easy VPN 2801 hardware client (Network Extension Mode).I successfully disable NAT for traffic traveling in to the tunnel, but I couldn't disable NAT for the split tunnel traffic. NAT still translating traffic with the o...

hello, I have configured a firewall ezvpn a handle 5520 and a router 881. this  worked all right, my question is: Is there any way to automate the  connection of the router with the firewall so we would not always be  entering the command "crypto ip...

My IT department is requiring an upgrade of the Cisco AnyConnect Client.  I am not sure what version I had before, but I believe it was a 3.x version.  That version was working fine.  However, whenever I try to install the Cisco AnyConnect version 2....

Hi I have a problem with ipsec tunel on ASAPhase I is OKbut phase II is weardlet's say local ip is 200.4.250.10local host 192.168.0.1/32remote net 172.20.0.0/16peer ip is 100.30.20.10-----the output of show crypto ipsec sa gives:local ident (addr/mas...

Hi All, I've configured ssl/web VPN on a cisco 1941 however when I try to connect no page displays.. It simply just times out... We are running a Cisco 1941 + Security... IOS =  Version 15.0(1)M2    (c1900-universalk9-mz.SPA.150-1.M2.bin)Running conf...

Hi,I have setup both webvpn and anyconnect for someone on an ASA5510 8.0(2). There a file bookmarks and an OWA( outlook web access) link configured.This all works fine with firefox and Internet explorer, however when using Safari things go horribly w...

Hello everyone, I’m trying to connect using the VPN client version 5.0.07.0290 (installed on Windows 7 x64) using a connection entry using a certificate authentication. The profile host is correct, also the certificate is correct. However I cannot es...

Hi,We are having problems with Anyconnect client after upgrading from 2.4.x to 2.5.0217, but only on some computers.We've made tests on some computers and it works fine, but on two PC's there is a problem which we can see on ASA like this:4|Jul 22 20...

Hello to everybodyMy System:Win 7 x64 ProfessionalCisco Anyconnect VPN Client 2.4.1012Group: ssl_GrpMy Problem is:If the Anyconnect Client is connected to our Uniiversity network (For Internetaccess), it will not be possible to syncronise the PDA via...

The release note of IOS 15.1.(2)T mentioned that the support ikev2 is available. However, when i used the Feature navigator it shows that ikev2 support is unavailable in ISR G1 router series. I could only found the support of ikev2 with the combinati...

Hi,we're on working with Cisco ASA 5520 and IOS 8.2I would like to use Sharepoint with SSL VPN: how can I activate passthrought authentication, using the same ID and password used to access on SSL Cisco web portal into Sharepoint session ?Thanks in a...

Hi,I am currently doing some research on a setup for a datacenter.  I am   attaching what I have in mind for clarity.  Basically we will have two ISPs   using fiber connectivity and we will use BGP on the ISR to perform dynamic   routing between the ...

Hi,I have a PIX 506e and an 1841 that I have used to establish a site-to-site vpn.  Servers are located behind the PIX that the users behind the 1841 access through a Win2k3 Terminal server which is also behind the PIX.  I have about 14 users at the ...